Atid ATS200 Panduan Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Pembaca kode batang Atid ATS200. Atid ATS200 15 halaman.

Halaman Cetak

Button Operation

1. Power On

1)
Turn on the power by pressing the power button
2)
If the communication mode LED blinks after the buzzer sounds, the power is on.
If the gun handle has been disassembled and reassembled, the instrument will not power on
immediately when the power button is pressed. This is not a malfunction, but a procedure to
check the battery status when first connecting the battery. In this case, if you hold down the
power button longer than normal, it will power on normally.

2. Power Off

1)
If the power button
2)
If the communication mode LED turns off after the buzzer sounds, the power is off.

3. Data Communication Mode Setting

1)
Press the communication mode switch button
data communication mode' and 'USB data communication mode'.
2) It takes about 2~3 seconds to change data communication mode.

4. Switch Barcode / RFID Function

Each time the Barcode/RFID toggle button
mode is sequentially
switched.
'Trigger input mode' is a mode in which the barcode or RFID reading function does not operate
when a trigger signal is input and only the trigger signal is input to the host device.
is pressed while the power is on, the power is turned
is pressed, the 'Barcode', 'RFID', 'Trigger Input'
8
until the buzzer sounds
to sequentially switch between 'Bluetooth
ATS200 User Guide
.
off.