Bosch Instructions for Use Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Pengering Bosch Instructions for Use. Bosch Instructions for Use 32 halaman. 24" compact condensation dryer axxis - white
Juga untuk Bosch Instructions for Use: Panduan Petunjuk Pemasangan dan Pengoperasian (32 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Petunjuk Instalasi dan Penggunaan Manual (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman), Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan (24 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan (24 halaman), Petunjuk Pengoperasian dan Pemasangan (29 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (10 halaman), Panduan Petunjuk Instalasi (12 halaman), Buku Petunjuk (8 halaman)

Drain pump

Draining the water

Cleaning the drain pump

Filter in the water

supply hose

Descaling the

washer-dryer

Take the drain hose out of the retainer.

Remove the plug from the drain hose and release the washing water.

– The container for the drained water may have to be emptied several

times.

– When no more water runs out, replace the plug.

Place the drain hose into the retainer.

Unscrew the pump cover.

– Clean the pump housing and remove any foreign objects.

– Make sure that the impeller can turn freely.

Replace the pump cover and screw firmly in place.

Place the kick panel in the 4 clip-in slots and secure to the housing

using the lock pins.

If no water runs into the washer-dryer, or only an insufficient amount, you

must first reduce the water pressure in the supply hose:

Turn off the tap.

Choose any programme (except

+ Spin).

Press the A (Start/Pause) button.

Allow the programme to run for approximately 40 seconds.

Set the program selector to Off.

Unplug the mains plug from the socket.

Unscrew the water supply hose from the tap.

Clean the filter with a small brush.

Reconnect the hose.

Turn on the tap.

Check whether water comes out of the end of the hose.

If water is escaping, check that the filter is correctly seated.

This should not be necessary if the correct detergent dosage has been

used. If it is necessary, however, proceed according to the descaler

manufacturer's instructions. Suitable descalers can be purchased from

our web site or via our after-sales service → page 22.

Turn the programme selector to Off.

Use a screwdriver to release the lock pins.

Tip the kick panel and pull upwards to remove.

' + B

Rinse

Spin /

[+ B

Drain