Community C SERIES CP6 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pembicara Community C SERIES CP6. Community C SERIES CP6 8 halaman. Pendant loudspeaker 6.5" full-range

Halaman Cetak
Installation and Wiring
Two 2-pole Euroblock connectors are
supplied and connect to a jack on the
top of the loudspeaker as shown in
Figure 4. Thread the audio cable down
through the loudspeaker top cover,
and then strip approximately 1/4-inch
(4mm) of insulation from the cable's
inner wire conductors. Insert the wire
ends into the Euroblock connector
terminals using the proper polarity
(marked on connectors and jack). If
you daisy chain an audio cable to the
next loudspeaker, bring it through the
top cover as well and connect that
second cable's wire pair to the other
Euroblock connector. Secure all wires
by tightening the screws in the end of
the Euroblock connectors.
Insert the Euroblock connector(s) into
the jack on top of the loudspeaker
as shown in Figure 5. No jumper
is necessary because the pairs of
conductors in the Euroblock jack are
internally connected to pass the signal
through.
Adjust the loudspeaker height as necessary (Figure 6).
1. Lift and support the loudspeaker with one hand (6-A).
2. Pull the main support cable end to take up the slack (6-B). (The split cover
plug is not yet pressed into position in this illustration).
The Gripple Speed Clamp automatically tightens from the cable tension when
you allow the loudspeaker to hang. Test by gradually lowering your hand. Don't
just "drop" the loudspeaker. When you have the proper height set, then take up
the slack on the safety cable by pulling its free end. Since the loudspeaker is
already held by the main cable it isn't necessary to support it while doing this.
Note: It is best to begin with the loudspeaker lower than the anticipated final height, and
lift it into position. It can be lowered later if needed by using the Gripple Setting Key, as
shown in Figure 7, but best practice is to set the height primarily by raising the unit.
C SERIES - CP6
(continued)
Euroblock connector
Figure 4. Insert and secure wires and
plug connector into socket
Installation Guide
Figure 5. Wire and insert second
connector for daisy-chain connection to
another loudspeaker
B
Split Cover Plug
A
Figure 6. Adjust height of the
loudspeaker
A
Page 5