Bosch 6 Series Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 27

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Pengering Bosch 6 Series. Bosch 6 Series 36 halaman. 2 door top freezer, inox-easyclean
Juga untuk Bosch 6 Series: Panduan Pengguna (24 halaman), Petunjuk Instalasi dan Penggunaan Manual (20 halaman), Petunjuk Instalasi dan Penggunaan Manual (20 halaman), Petunjuk Instalasi dan Penggunaan Manual (20 halaman), Buku Petunjuk dan Petunjuk Instalasi (48 halaman), Buku Petunjuk (16 halaman), Buku Petunjuk (48 halaman), Panduan Petunjuk Instalasi (27 halaman), Buku Petunjuk (12 halaman), Buku Petunjuk (16 halaman), Petunjuk Instalasi dan Penggunaan Manual (16 halaman), Petunjuk Penggunaan Manual (29 halaman), Panduan Pengguna dan Petunjuk Instalasi (16 halaman), Informasi Untuk Penggunaan (32 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Informasi Untuk Penggunaan (28 halaman), Panduan Pengguna (23 halaman), Buku Petunjuk (24 halaman), Petunjuk Instalasi Dan Petunjuk Penggunaan (24 halaman), Informasi Untuk Penggunaan (16 halaman), Panduan Pengguna (36 halaman), Panduan Pengguna (32 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna (28 halaman), Buku Petunjuk (28 halaman), Informasi Untuk Penggunaan (20 halaman), Buku Petunjuk (28 halaman)

Halaman Cetak
Bosch 6 Series Panduan Petunjuk Pemasangan dan Pengoperasian
D

Cleaning

C leaning the dryer and the
C l e a n i n g
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.

Cleaning the heat exchanger

Notes
Clean the heat exchanger several
■
times a month if you use the dryer
more than twice a week.
If there is debris in the heat
■
exchanger, this will increase the
amount of time required for drying
and will compromise the drying
results.
Allow the dryer to cool down and
1.
place an absorbent cloth beneath
the maintenance flap.
Residual water may leak out.
Note:
Open the maintenance flap fully.
2.
Turn both locking levers towards
3.
each other.
Remove the top cap from the heat
4.
exchanger.
Remove the heat exchanger.
5.
Flush water through the heat
6.
exchanger from all sides to
completely remove all fluff.
Caution!
There is a risk of damage to the heat
exchanger.
Only use water to clean the heat
exchanger, and do not use any hard
objects or objects with sharp edges
to remove the fluff.
Remove all fluff from the seals on
7.
the dryer and on the heat exchanger.
Allow all the water to drip off.
8.
Cleaning
en
27