Community Distributed Design DS8 Panduan Instalasi dan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pembicara Community Distributed Design DS8. Community Distributed Design DS8 12 halaman. Distributed design series surface mount loudspeakers
Juga untuk Community Distributed Design DS8: Panduan Pemilik Pemeliharaan Instalasi dan Pengoperasian (12 halaman)
Halaman Cetak
Vertical mounting
5. Adjust the cabinet position by rotating and
tilting as desired. Then firmly tighten the locking
screw with the provided hex wrench.
Horizontal mounting
Horizontal Mount Maximum Aiming Angle
DS5
A
8°
B
20°
C
64°
Vertical Mount Maximum Aiming Angle
DS5
A
39°
B
39°
C
31°
Note: This enlarged label shows the
70-volt/100-volt and 8-ohm power tap settings
for the DS8. With 100-volt distribution, do
not use the N.C. setting.
Distributed Design Series
Surface Mount Loudspeakers
6. Using a small slot-blade screwdriver (like the
one provided) you can pry the logo plate out a
few millimeters, then rotate it 90° and press it
back in place so it reads correctly for horizontal
or vertical mounting.
7. Once you have connected the wiring (next
page), you can also remove the logo plate for
access to the recessed tap-adjustment screw
DS8
which you can use to set the power level for the
8°
individual loudspeaker as shown below.
11°
59°
DS8
39°
39°
33°
Installation and Operation Manual
Note: The tap switch can only
be
adjusted
using
screwdriver such as the one provided
with the loudspeaker.
a
flat-blade
Page 8