Andersen Windows & Doors 901724 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Pengendalian Serangga Andersen Windows & Doors 901724. Andersen Windows & Doors 901724 14 halaman. 1-1/2” self-storing storm doors with balanced retractable insect screen and integrated close system

Halaman Cetak
INSTALL RAIN CAP
EXTENDER, SCREW
5
COVERS, & WINDOW
HANDLE
(Left Hand)
a
OPTIONAL
C
1.
If there is a gap above your door, you will
need to install the rain cap extender (C).
If not needed, dispose of properly and skip
to step 5c.
2.
Place the rain cap extender over the rain cap
as shown, with both ends centered over the
rain cap.
d
N
1.
Install end covers into rain cap. Pressing round
button down on end cover (N), slide end cover
into rain cap until it is secured.
2.
Repeat for other side.
C
L
Rain Cap Extender
Screw
Covers
(optional)
b
OPTIONAL
1.
Using 1/8" drill bit, drill holes in brickmould
through holes in rain cap extender.
2.
Fasten the rain cap extender to the mounting
surface using three 1" screws. Do not
overtighten screws.
NOTE: Be careful not to hit rain cap with drill
driver.
X
e
VIEW
DOOR SILL
If necessary, adjust the sweep (G).
1.
If there is a gap between sweep fins and
door sill or if the sweep fins bind on door
sill when opening, adjust the sweep.
2.
From interior of the panel, loosen the
sweep screws with a phillips screw driver.
Adjust the sweep up or down until the
sweep fins lightly come into contact with
the door sill.
3.
Retighten the sweep screws.
1/2" Self-Drill Pan Painted
5/8"
1/2"
3/4" Machine Flathead
N
Q
1 1/2"
7/8" Machine Pan Painted
1 1/2"
End
Handle
1" SMS Pan
Cover
Kit
1" SMS Pan Painted
1" Machine Pan Painted
1-1/2" Machine Flathead
#10
1-1/2" Machine Flathead
2" SMS Pan Painted
1.
#12
5/8" SMS Pan Painted
i
VIEW
SWEEP FINS
G
SWEEP
6
1/2"
Tools needed:
1"
2"
1/8"
1"
(optional)
!
c
L
5/8"
L
5/8"
Install screw covers (L) into side rails and
rain cap extender (if installed). Insert side
1 1/2"
of screw cover into the side of the screw
track. Press on other side to snap it into
screw track. Make sure they snap the entire
length of the channel.
1 1/2"
f
Q
1.
To attach window handle, located
in window handle kit (Q), first lower
venting window so pre-drilled holes
are at a comfortable working height.
2.
Align holes in window handle and
ventilating window frame, secure
with two 3/4" screws (provided in
window handle kit).
x 3
!
1/2"
2"
i
VIEW