Installation
-
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation
location.
5. Have the power supply cord
fitted by an authorized
technician
(see page 8).
6. Move the dryer to its final
location and level.
Do not slide dryer across the
floor if height-adjustable
feet
have been extended.
Feet and/or
dryer base may be damaged
if
dryer is slid across floor with
height-adjustable
feet extended.
7. Position and then level the
dryer.
The dryer should be level with
all feet firmly on the ground.
The dryer must not wobble.
If the dryer is not level or if it
does wobble, the feet must
be adjusted.
Adjust the
height-adjustable
feet until the
dryer does not rock and is level,
both front-to-back
and
side-to-side.
8. Reinstallation
of the dryer at the
new location - refer to the
installation
instructions
(see
page 6)
9. Insert plug into the wall
receptacle.
Check list before
using the dryer
1. Check that steps 1-8 have
been implemented
properly.
2. Ensure that the dryer is
connected
to the power supply.
3. Read the operating
instructions
to understand
how your dryer
operates.
4. Conduct
an appliance
test:
1_7Check that the drum is
empty.
1_7Close the dryer door.
,
,
1_7Switch the dryer to Very dry
and then press the Start
button.
1_7After 3-5 minutes press the
Stop button and open the
door.
If the interior of the dryer feels
warm, the dryer has been
connected
properly.
Switch the dryer to Off.
If the dryer does not work,
switch the dryer to Off.
Look in the troubleshooting
section (see page 19) of the
OPERATING
INSTRUCTIONS
and find the fault,
Preparing
to transport
the dryer-
step
by step
1. Rotate the program
selector
to Off.
2. Pull out power supply plug.
3. Place any accessories
in the
drum.
.
,
Close the door and secure with
adhesive tape.
Screw the height-adjustable
feet of the dryer into the
housing to prevent them from
being damaged
during
transportation.
10
Halaman Cetak