Bosch WTA35 Series Petunjuk Perbaikan - Halaman 13
Jelajahi secara online atau unduh pdf Petunjuk Perbaikan untuk Pengering Bosch WTA35 Series. Bosch WTA35 Series 15 halaman. Electric vented dryer, electric condensation dryer
Juga untuk Bosch WTA35 Series: Petunjuk Penggunaan Manual (44 halaman), Panduan Penggunaan dan Perawatan (24 halaman)
Halaman Cetak
TUMBLE DRYER
Error
Error display
no.
18
Starts by itself when
switched on.
VI.
SUPPLEMENTS
1.
Power and control module
Changed software mask 3 (software version V 3.00 is indicated on the processor).
Reduced heat output in the time programme.
Empty drum or dry washing identified within 5 minutes (–2 % relative humidity).
Clocking at reduced heat output.
No stop function when start button pressed again.
2.
Spark discharge between belt clamping device and motor connector plug
Drive belts were occasionally manufactured with an insufficient carbon content, resulting in
a static charge build-up between the belt wheel and drive belt. In these cases the drive belt
(Mat. no.: 15 4142) must be replaced.
3.
Improvement in temperature control in the heat registers
All heaters will receive a new thermal cut-out (modified design). Thermal cut-outs
(Mat. no.: 15 4132) and NTC (Mat.: no. 15 4186) are no longer available as spare parts.
If required, heaters in appliances with customer-service index /01 should be completely
replaced.
4.
Increase to customer-service index /02
Individual parts of the heater (NTC and thermal cut-out) are available again as spare parts.
r120085e -15/13
04.99
Possible cause
Appliance was switched off
during a drying cycle.
Test / Procedure
Customer information:
If the appliance switches off
and subsequently switches
on again while a drying
programme is running, the
appliance is starting by itself
in order to terminate the
programme which was
started.