Bosch WTA74100ZA Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Pengering Bosch WTA74100ZA. Bosch WTA74100ZA 8 halaman.
Juga untuk Bosch WTA74100ZA: Fitur dan Spesifikasi (20 halaman)
Halaman Cetak
Installation
Technical data
– Scope of delivery: dryer, instruction manual and installation instructions.
– Check dryer for transport damage.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not install in a room where there is a risk of freezing.
Freezing water can cause damage.
– If in doubt, have the appliance connected by a specialist.
Setting up the dryer
Remove all accessories
1.
from the drum. The drum
– The mains plug must always be accessible.
– Ensure that the appliance is installed on a clean,
must be empty.
level and firm surface.
– Install the exhaust air duct -> Installation
instructions for exhaust air duct.
– Keep the area around the dryer clean.
– Level the dryer using the front threaded feet.
– Do not unscrew the threaded feet more than
20 mm.
On no account remove the threaded feet.
Do not install the dryer behind a door or
sliding door which could prevent or
obstruct the dryer door from opening.
This will prevent children from locking
Clean and level
themselves in and risking their lives.
Mains connection
For safety instructions, -> page 11.
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (-> page 9) must be the same.
– The connected load and necessary fuse protection are specified on the rating plate.
Optional accessories
Ordering
code
WTZ
1130
WTZ
11311
WTZ
10290
WMZ
20460
8
7
What to do if ...
Dimensions (DxWxH)
60 x 60 x 85 cm
Repairs must only be carried out by the after sales service or an authorised specialist.
Before contacting the after-sales service, please check whether you can remedy the fault
Weight
approximately 35 kg
yourself. When you contact the after-sales service, you will be charged call-out costs if a
technician is required, even within the warranty period. You can find your nearest after-sales
Max. capacity
6 kg
centre from the list enclosed. When contacting the after-sales service, please quote the product
Ambient temperature
5 - 35 °C
number (E no.) and the production number (FD) of the appliance ( -> inside of the door).
Connection voltage
220 - 240 V
Start/Stop indicator light does
not light up.
Connected load
2200 W
Fuse protection
10 A
Filter/Vent/Hose indicator light
Product number
flashes.
-> Rating plate or inside of the door
Production number
You can find the rating plate on the back of the dryer.
Consumption rates
These are guide values determined under standard
Dryer does not start.
conditions. Deviations of up to 10% are possible.
Spin speed rpm
Drying time** in
Energy
(residual moisture)
min incl. 8 min
consumption**
Programme terminated shortly after
cooling time
in kWh
starting.
Cottons 6 kg
Water is leaking out.
Cupboard dry*
1400 (approx. 50 %)
100
3.00
The door opens by itself.
1000 (approx. 60 %)
105
3.25
The required degree of dryness
800
(approx. 70 %)
140
4.00
was not achieved or the drying time
Iron dry*
1400 (approx. 50 %)
78
2.20
was too long.
1000 (approx. 60 %)
80
2.40
800
(approx. 70 %)
100
3.00
Easy-care 3 kg
Cupboard dry*
800
(approx. 40 %)
38
1.00
600
(approx. 50 %)
50
1.30
Laundry damp.
*Test programmes according to DIN EN 61121.
**The values may diverge from those specified depending on overvoltage and undervoltage,
fabric type, composition of the laundry to be dried, residual moisture in the fabric and the
The humidity in the room has
amount of the load.
increased significantly.
One or more indicator lights are
flashing.
Exhaust air duct set
(according to model)
The exhaust air is extracted via a hose.
Power cut.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
Condensation in the exhaust air
to save space.
duct.
The dryer must be fastened to the washing machine using this connection set.
Built-under installation
If you cannot rectify a fault yourself or a repair is necessary:
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
– Turn the programme selector to o (Off).
– Remove the mains plug from the socket.
– Call the after-sales service -> after-sales service directory.
Platform
For improved loading and unloading. The basket located in the drawer can be used for
carrying laundry.
9
Safety instructions
Emergency
– Pull the mains plug out of the socket immediately or disconnect the fuse.
ONLY use the
– In rooms inside the house.
dryer...
– for drying fabrics.
The dryer must
– Be used for other purposes than those described above.
NEVER...
– Be modified in terms of its technology or attributes.
Mains plug plugged in?
Dangers
– The dryer must not be used by children or persons who have not been
Programme selected?
instructed in its use.
Check the socket fuse.
– Do not leave children unsupervised near the dryer.
Clean the fluff filter -> page 4.
– Keep pets away from the dryer.
Exhaust air duct blocked or bent?
– Remove all objects from the pockets of garments.
Clean the exhaust air duct -> page 6.
Pay particular attention to cigarette lighters -> risk of explosion
If necessary, clean the insect screen on the exhaust air
– Do not lean or sit on the door -> risk of tipping.
pipe.
– Open the door with care. Hot steam may escape.
Start/Stop button pressed?
Installation
– Fasten down loose leads -> risk of tripping
Door closed?
– Do not operate the dryer where there is a risk of frost.
Programme set?
– The safety information in the separate installation instructions for the exhaust
air duct must be observed without fail.
Ambient temperature greater than 5 °C?
– Connect the dryer to an AC earthed socket according to specifications, as
Mains
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
Make sure the dryer is level.
– The cable cross-section must be sufficient.
Push the door closed until you hear it engage.
– Only use earth-leakage circuit breakers with the following symbol:
– The mains plug and socket must be compatible.
Clean the fluff filter -> page 4.
– Do not use multiple plugs/couplings and/or extension cables.
Ambient temperature higher than 35 °C -> ventilate the
room.
– Do not touch or hold the mains plug with wet hands -> risk of electric shock.
– Never pull the mains plug out of the socket by its cable.
Unsuitable programme selected? -> page 7.
Dryer installed too closely to other objects? Provide
– Do not damage the mains lead -> risk of electric shock.
adequate air circulation.
– Only load the drum with items of laundry.
Operation
Mains failure -> Restart the dryer.
Check what has been loaded before switching the dryer on.
Fine layer of limescale on the moisture sensors. Clean the
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
sensors -> page 6.
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.) -> fire/explosion hazard.
Use the next drying programme up or the timer
programme -> page 7.
– Dust danger (e.g. coal dust or flour): do not use the dryer
Warm laundry feels damper than it really is!
-> risk of explosion.
– Do not put laundry containing foamed material/rubber in the dryer -> elastic
Make sure the room is sufficiently ventilated.
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
Clean the fluff filter -> page 4.
– Switch off the dryer once the programme has ended.
Check the installation conditions -> page 8.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Exhaust air duct blocked or bent?
Repairs must only be carried out by the after-sales service.
Clean the exhaust air duct -> page 6.
– Do not use the dryer with a faulty mains cable. In order to avoid risk, have the
Switch off, allow to cool, switch back on and restart the
mains lead replaced only by our after-sales service.
programme.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Remove the laundry from the dryer immediately and
spread it out. Heat may escape.
Disposal
– Dryer: Disconnect the mains plug, then cut the mains cable off the appliance.
Dispose of the appliance at a public disposal site.
Exhaust air duct too long? Check the maximum exhaust air
– Packaging: Do not allow children access to items of packaging
duct length. Further information -> Installation instructions
-> risk of suffocation
for exhaust air duct.
– All materials are environmentally friendly and reusable. Dispose of in an
environmentally responsible manner.
10
en
Tumble dryer
Installation and
operating instructions
Read the instruction manual and installation instructions before
operating the dryer.
Observe the safety instructions on page 11.
11