ANDERSON-NEGELE NSL-F-01 Panduan Pengoperasian - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Aksesori ANDERSON-NEGELE NSL-F-01. ANDERSON-NEGELE NSL-F-01 20 halaman. Continuous level sensor.
sensors for food and biopharma.
Juga untuk ANDERSON-NEGELE NSL-F-01: Panduan Pengoperasian (20 halaman)
Halaman CetakNSL-F Series Operating Manual
Attention: The connector of the programming adapter (Fig. 3) must be connected in the correct direc-
tion the green spacer must face the cable exit (M12 connector or PG).
7.2
Retrofitting the display if a small display (SUI) was already installed
First the puck with the mounted display needs to be removed using the puck puller tool (Fig. 1). To do
so, detach the wires from the cable terminal. Then insert the five arms of the puck puller in the plastic
tabs of the puck (Fig. 2).
Fig. 1
Push the puck puller all the way into the sensor head and push
the disk as far as possible toward the sensor head so that the
arms of the puck puller firmly grasp the puck.
Pull the puck with the display out of the sensor housing and pull
the small display off of the puck.
Now the puck without the display can be properly positioned and installed back in the sensor head
and the wiring can be reconnected to the cable terminal. Then the large display can be mounted
see "Retrofitting the display if a display was not yet installed".
7.3
Operating the large display
The large display (LUI) is operated in the same way as the small display (SUI). It is operated using two
operating buttons below the display:
After the sensor is started, the screen saver appears in which the process values of the sensor are
displayed one after the other. To reach the start page from here, press one of the two buttons briefly.
Further information on operating the display can be found in the quick start manual and in the operat-
ing manual for the modular sensors (ILM-4, NSL-F...).
Fig. 2
fig. 3
13