Carol-Ann Custom Amplifiers OD-2 Series Panduan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penguat Carol-Ann Custom Amplifiers OD-2 Series. Carol-Ann Custom Amplifiers OD-2 Series 11 halaman. 50w & 100w amplifier

Halaman Cetak

Rear Panel

1.
IEC Connector – Mains power connector.
2.
Supply Selector (Export only) – Set the Amplifier to run on 115V~ or 230V~.
3.
Power Fuse – Fast Blow. 50W – 3A, 100W – 5A.
Warning: Always replace fuse with correct type and rating.
4.
Power Switch
5.
Standby Switch
6.
HT Fuse – Slow Blow. 50W – 0.5A, 100W – 1A
Warning: Always replace fuse with correct type and rating.
7.
Speaker Output – 8 ohm Speaker Output
8.
Speaker Output – 16 ohm Speaker Output
9.
Effect Loop Return Jack – Connect to the output of the effects you want to run in the effects loop.
10.
Effect Loop Send Jack – Connect to the input of the effects you want to run in the effects loop.
Page 6 of 11