Dreamotion Frameset Series Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Perabotan Dalam Ruangan Dreamotion Frameset Series. Dreamotion Frameset Series 9 halaman.

Halaman Cetak
Add Additional Leg Supports For Slat/Platform Foundation.
Support legs may be needed on some slat/platform foundation, refer to the leg configuration table for height
adjustment.
Leg Configuration Table（Optional）
3"
6"
9"
Electronics Quick Reference Guide
Under-Bed Lighting
Head Motor
Foot Motor
08
3 "
6 "
9 "
USB Charger
Y-cable
Power Supply
DC Power Cord
JCB35H7A1
Head
Foot
Sync
APP
Motor
Motor
Bluetooth
Wireless Remote
Synchronizing Two Foundations
If simultaneous operation of two foundations is desired, use the sync cord to connect the electronics of both
foundations together.
(single bed only)
Head
Motor
Triplex Cable
Wireless Remote
STEP 1：Unplug foundations from the power source.
STEP 2：Connect the male ends of the sync cord to the female sync plugs of the control boxes (Refer to
illustration above).
STEP 3：Plug foundations back into the power source.
STEP 4：Open the battery box and toggle the switch to "P" position first, then press any other button except
for "FLAT", next press and hold "FLAT" until you hear a beep sound of each buzzer on the control
box, which means the two foundations can be synchronized with one remote.
STEP 5：Open the battery box and toggle the switch to "A" or "B" position, you can control the two foundations
separately without removing the sync cord.
Attention: (1) If to control two foundations separately, either toggle the switch on one battery box without removing
the sync cord from both foundations, or use two wireless remotes with removing the sync cord from
both foundations. (2) The quadded cable is in master control when synchronizing. (3) The interval must
more than 4s between plug in and plug out the sync cord.
Remote Pairing
The original remote that comes in the box is already paired to the foundation. No further action is required.In
the event that the remote is not paired with the foundation, follow the steps below.
1.
Unplug the foundation from the power source then power it on,defaulting to remote pairing within 30s.
2. Next press and hold
at the same time.
3.
You will hear a beep sound of the buzzer and the backlit light of the wireless remote flashes two times, which
means the pairing is successful.
JCB35H7A1
JCB35H7A1
Foot
Head
Foot
APP
Sync
APP
Sync
Motor
Motor
Motor
Quadded Cable
Sync Cord
JCB35H7A1
Head
Foot
APP
Sync
Motor
Motor
09