Andino X1 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Mikrokontroler Andino X1. Andino X1 15 halaman. Raspberry pi extension with integrated signal preprocessing

Halaman Cetak

Programming the microcontroller

The Arduino development environment can be used to program the microcontroller. Install this first.
Under Tools select the controller type
"Arduino Pro or Mini" and for processor then ATmega 168 3.3V 8Mhz.
Set the jumpers on the Andino X1 to "USB Configuration". Now the board can be programmed with the
Arduino IDE.
From the Raspberry Pi, the controller can be programmed with the tool AVRDude and / or Ino. Please
read the corresponding blog entries at https://andino.systems.
The pins for the optocouplers and relays are as follows:
INPUT_1
6
INPUT_2
7
OUTPUT_1
14
OUTPUT_2
5
Clear Systems GmbH • Schweinthal 25 • 91349 Egloffstein • Tel. (09197) 23 53 23 5 •
Stand: 07.01.2019
www.andino.systems
•Seite: 10/15