Caroma G Series Panduan Instalasi dan Pemeliharaan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemeliharaan untuk Dispenser Caroma G Series. Caroma G Series 17 halaman. Electronic soap dispenser
Juga untuk Caroma G Series: Panduan Petunjuk Pemasangan dan Pemeliharaan (16 halaman), Panduan Petunjuk Pemasangan dan Pemeliharaan (16 halaman), Panduan Instalasi dan Pemeliharaan (16 halaman)

SETTINGS ADJUSTMENT

DELAY OUT TIME: This button allows modifying the water flow time after the user removes his hands

from the outlet. A delay out time close to 0 will save more water. An increased delay out time will

make the user experience more comfortable.

If required, the delay out time can be modified as follows:

Press the OUT button. Wait until a quick flashing of the LED in the sensor eye is perceived. Then,

press + to increase the delay out time and – to reduce it.

24 HOUR HYGIENE FLUSH: This model includes a 24 hours hygiene flush which is disabled. To activate

the hygiene flush, press the clock button. Wait until a quick flashing of the LED in the sensor eye is

perceived. Then press + to activate the hygiene flush. To disable it again, press – to deactivate it.

COMFORT FLUSH: If your model includes a Comfort flush setting, it can be activated by pressing the

flush button. When the button is pressed, one blink of the LED in the sensor eye is perceived. The

pre-programmed flush cycle will take place then.

The Comfort flush cannot be interrupted or deactivated by pressing any button until it is over.

TEMPORARY OFF FUNCTION: This function is ideal to perform any kind of activity in front of the sensor

without operating the system (for example, cleaning).

The outlet will remain shut for 1 minute when this button is pressed once. To cancel this function and

to return to normal operation press the On/Off button again or wait 1 minute.

RESET BUTTON: This function restores all the factory settings except for the sensor range. If required,

press the Reset button and without releasing it, press the + button once.

Note: To enter the self adjusting mode, use the ADJ button. To change the sensor range, use the RANGE button.