Caroma G Series Panduan Instalasi dan Pemeliharaan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemeliharaan untuk Dispenser Caroma G Series. Caroma G Series 17 halaman. Electronic soap dispenser
Juga untuk Caroma G Series: Panduan Petunjuk Pemasangan dan Pemeliharaan (16 halaman), Panduan Petunjuk Pemasangan dan Pemeliharaan (16 halaman), Panduan Instalasi dan Pemeliharaan (16 halaman)

PRE-INSTALLATION INFO

CHECK CONTENTS

Separate all parts from the packaging and check each part with the pack contents section. Pay attention to the

variations of the different models.

Make sure all parts are accounted for before discarding any packaging material.

If any parts are missing, do not attempt to install your electronic outlet until you obtain the missing parts.

WARNING

1) To avoid reflection problems keep a distance of more than 300 mm. between

the washbasin and the spout.

2) This outlet model, with an infrared sensor pointing down, is not intended

to be used together with a washbasin of a reflective material such as

stainless steel.

3) If a washbasin strainer is straight below the outlet sensor, use a strainer with

a non reflective finish (do not use a chrome plated one).

PREPARATION FOR INSTALLATION

Flush the water supply lines thoroughly before installing the outlet. Do not allow dirt, teflon tape or metal particles

to enter the outlet. Shut off water supply.

IMPORTANT: All plumbing is to be installed in accordance with applicable codes and regulations.

Installations in Australia and New Zealand must comply with the requirements of AS/NZS 3500.

Min 300 mm.

Bottom of the washbasin