DREAMVISION DreamWeaver II Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Proyektor DREAMVISION DreamWeaver II. DREAMVISION DreamWeaver II 13 halaman. Digital cinema projector

Halaman Cetak

Modiﬁcation of the Page 30 of the User's Guide

Service: to use these features, highlight them and press Select.

Factory Reset: restores all settings (except Lamp Hours, Ceiling, and Rear)

to their default after displaying a conﬁrmation dialog box.

Test Pattern: displays a test pattern when the Blank button on the remote

is pressed. To select the patterns, use the up/down arrows on the remote or

keypad.

Blue only : Tuns off the Red and Green portions of the input, allowing you

to properly adjust the color balance with a SMPTE color bar pattern.

Color Wheel Index: Makes the hue of various gray levels consistent.

ADC calibration: allows adjustment of thee calibrated ADC values so that

color accuracy can be optimized. Adjust the slidebars for each value and

note the change in the appropriate color. Use a component input when

adjusting the component controls.

Service Code: only used by authorized service personnel.

Maintenance

Cleaning the lens

Apply a non-abrasive camera lens cleaner to a soft, dry cloth.

Avoid using an excessive amount of cleaner, and don't apply the

cleaner directly to the lens. Abrasive cleaners, solvents or other harsh

chemicals might scratch the lens.

Lightly wipe the cleaning cloth over the lens in a circular motion. If you

don't intend to use the projector immediately, replace the lens cap.

clean the lens

with a soft dry cloth

and non-abrasive

cleaner

Service menu