Electrolux EGG64272M Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Electrolux EGG64272M. Electrolux EGG64272M 20 halaman.

Halaman Cetak

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with the

regulation in force. If you use flexible metallic

pipes, be careful they do not come in touch

with mobile parts or they are not squeezed.

Also be careful when the hob is put together

with an oven.

Make sure that the gas supply pressure

of the appliance obeys the recommended

values. The adjustable connection is

fixed to the comprehensive ramp by

means of a threaded nut G 1/2". Screw

the parts without force, adjust the

connection in the necessary direction and

tighten everything.

A. End of shaft with nut

B. Washer supplied with the appliance

C. Elbow supplied with the appliance

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

"Flexible" connection with mechanical

end:

• Natural gas: connection carry out with a

flexible pipe with mechanical end which is

screwed directly on the elbow finishing the

slope of the appliance.

• Butane/Propane: use a flexible tube,

equipped with it's collars if it is worth

visiting over all it's length and if the

appliance runs only on butane. If the

appliance runs on Propane, use a flexible

pipe with suitable metal end.

Flexible nonmetal pipes connection:

If it is possible to easily control the connection

in its full area, you can use a flexible pipe.

Tightly attach the flexible pipe by clamps.

ENGLISH

B C

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting edges

or corners;

• it can be easily examined in order to make

sure its condition.

The control of preservation of the flexible pipe

consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows its

correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is complete, make sure

that the seal of each pipe fitting is

correct. Use a soapy solution, not a

flame!

3.3 Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the ones

which are necessary for the type of gas

you use (see table in "Technical Data"

chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Attach the label with the new type of gas

supply near the gas supply pipe. You can

find this label in the package supplied

with the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you

must fit an applicable pressure adjuster on

the gas supply pipe.