Andon Health iHealth Track Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Tekanan Darah Andon Health iHealth Track. Andon Health iHealth Track 16 halaman. Fully automatic ihealth track connected arm blood pressure monitor

Halaman Cetak

Avoid compression or restriction of the connection tubing during measurement，which may cause

inflation error, or harmful injury due to continuous cuff pressure.

4. SETTING THE DATE AND TIME

Insert the batteries in the device and connect it with the iHealth MyVitals App on your smartphone. The

time and date will automatically be updated. If you change the batteries, please readjust the time and date

again.

5. TAKING A BLOOD PRESSURE MEASUREMENT

a. After placing the cuff on your arm and relaxing for a few minutes, press the "START/STOP" button. All

display characters are shown for self-test, please contact the service center if segment is missing.

b. The monitor will inflate the cuff and then slowly release pressure from the cuff as the blood pressure is

measured. When the measurement is finished the blood pressure and pulse rate will be displayed on the

display. The blood pressure will be displayed in different colours (green for normal, yellow for slightly

elevated, and red for high) according to the recommendations of the WHO (World Health Organization),

The result will automatically be stored in the memory bank of the monitor.

c. If an Irregular Heartbeat (IHB) is detected during a measurement, the IHB symbol will be displayed

(blinking). If an IHB is detected, the results of the blood pressure measurement may be inaccurate. Please

consult your physician for an accurate assessment.

d. At any time you can synchronize your device with the iHealth MyVitals App so that you can better

manage your blood pressure.

e. The monitor will automatically switch off after one minute to save the batteries. Alternatively, you can

press the "START/STOP" button to turn off the monitor manually.

f. At any time during a measurement, you can interrupt a measurement by pressing the "START/STOP"

button.