Compac MR160P Petunjuk Instalasi dan Pengaturan - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Pengaturan untuk Dispenser Compac MR160P. Compac MR160P 18 halaman.

Dispensing Hoses and Nozzles

The unit may or may not be supplied with dispensing hose and nozzle assemblies.

If customer supplied hose assemblies, pylons, reels, safe breaks and nozzles are used they must

comply with the requirements outlined in AS/NZS 2229.

9.1

For all dispensers fitted with breakaways, ensure the breakaway is installed between the nozzle

and the high-mast or pylon (if fitted). Any breakaways that have been subject to a break-away

situation should be inspected and refitted or replaced in accordance with the original

manufacturer's instructions.

10.

Once the pump is connected on site, the final setup check and calibration to complete the

installation must be carried out, using the Parameter Switch and Calibration (K-Factor) Switch.

These switches are found on the C4000 Microprocessor Board which is housed in a metal

enclosure located on the left front of the unit below the display panel

10.1

The configuration code has been set at Compac and should not be changed

In the event of it being lost and having to be re-entered the configuration is written on the yellow

label on the C4000 processor board cover

10.2

10.2.1

Setting the Pump Number

This must be set at the pump, for each hose, so that communications with

a controller can take place. The location of this switch is shown in the

diagram below.

Depress the Parameter Switch nine (9) or more times until the message

'PnA XX' appears in the litres display window. When the switch is

pressed again 'Pnb XX ' will appear on the display. These two options

will toggle each time the switch is pressed. To alter either of the pump numbers, press and hold

the Parameter Switch when the pump number to be altered appears on the display. This number

will then increment. The switch should be released when the desired pump number is displayed.

The value of the displayed number will then be stored in the C4000 memory as the pump

number for that hose.

NOTE: For a single hose only 'Pn" will appear

\\Cilaklfs1\shrdata\Masters\Installation Sheets\Master & Premier\MR160P Installation

Sheet.doc

Page 10 of 18