Compac L160SD Petunjuk Instalasi dan Pengaturan - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Pengaturan untuk Pompa Air Compac L160SD. Compac L160SD 16 halaman.

Static Electricity Precautions

Electronic components used are sensitive to static. Please take anti-static precautions.

An anti-static wrist strap should be worn and connected correctly when working on any

electronic equipment. If an anti-static wrist strap is unavailable, or in an emergency, hold onto

an earthed part of the pump/dispenser frame whilst working on the equipment. This is not a

recommended alternative to wearing an anti-static wrist strap.

Note: Compac Industries Limited reserves the right to refuse to accept any circuit boards

returned, if proper anti-static precautions have not been taken.

Once the pump is received on site, check that no damage has occurred while in transit – in

particular, damage to electronics due to vibration or jarring. All terminals and plugs should be

checked, including IC chips, to ensure they are securely in place.

Installation should be in accordance with local regulations.

The dispensing equipment shall be installed to prevent the delivery hose from contacting the

ground when not in use.

Where local regulations require a sump to be fitted:

a. Sumps must be provided at all dispenser installations with secondary containment pipework

and at all new installations.

b. At all sites with sumps, dispensers should be installed with a liquid level detection device

fitted in the sump that will raise an alarm if liquid is detected in the base of the sump.

6.1

(Dipswitch SW3)

1-ON

2-OFF

3-ON

4-OFF

These are factory set to the standard setting unless ordered otherwise.eg Gilbarco.

6.2

(Special software and interface board required)

1-OFF

2-ON

3-OFF

4-ON

\\Cilaklfs1\shrdata\Masters\Installation Sheets\Laser\L160SD Installation Sheet.doc

Page 5 of 16