Compac WD1500 Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Gerobak Luar Ruangan Compac WD1500. Compac WD1500 9 halaman. Wheel dolly

Safety instruction - LOWERING / MOUNTING OF WHEEL

1. Release the safety pin (S).

2. Inspect that the small wheel (W) has a firm grip on the wheel/load before lowering.

3. Before lowering the wheel/load make sure that vertical guide lock (L) is released and free to

move.

4. Once you slowly start lowering the wheel/load, the guide arm (L) should be able to freely

follow the movement of the wheel. If not, the risk is that the wheel will drop away from its

support (W) on the opposite side of the wheel and could thereby accidentally fall.

5. Activate the pump lever (P) to lower the load or reach the correct mounting height.

6. Once the unit can be removed from the wheel/load, release locks (K) and swing wheel (W)

away from the wheel. Pull back the unit.

Safety instruction – MANOEUVRING WITH WHEEL/LOAD

1. Ensure that the small support wheel (W) is supporting the wheel/load correctly.

2. Ensure that the locks (M), (L) and (S) are in locked position.

WARNING Safety instructions:

Make sure that lifting only occurs on a flat and strong surface/floor.

The wheel/load must be lifted in a vertical angle as the wheel/load might otherwise slide on the

rollers away from the unit causing the unit to move towards the operator.

Do not overload the unit! Overloading with loads over 1600 kg could result in damage to the unit or

in worst case cause other damage and even accidents!

Lowering a load of more than 1600 kg onto the unit may lead to serious damage to the unit.

Example: If the operator lowers the vehicle itself before lowering and moving the wheel dolly away

from the vehicle.

Before lifting / transporting a load the operator MUST take precautions that the load is not allowed to

drop, and that the weight distribution is safe. The operator must before use take precautions that all

pins are safely locked with split pins or lock rings. (ATTENTION! The LOAD must be blocked with

the guide arm (K) locked and (W) in correct position to support the wheels on the opposite side.)

Always lower the load to the lowest possible position before transportation.

Important! The safety valve is calibrated and sealed by the manufacturer and it is ABSOLUTELY

PROHIBITED to open the seal or adjust its calibration. Offence against the above safety instructions

could in worst case result in loss of the load which could cause personal injury and/or damage to the

unit or properties. In case the unit has any irregularities which could affect the safety, the unit must

not be operated until it has been repaired.

The unit should not be used if there are any oil leakages or if the unit seems different to use than

when it was new. In such cases the unit should be inspected/repaired by a skilled person. More

information on spare parts, etc is available on www.compac.eu under "Services".

The manufacture is not liable for wrong use, changes to the construction, use of other spare parts

than original or adjustments/repairs by unauthorised persons.

Safety Maintenance:

Inspection of the unit must only be done without load, for safety reasons. Only authorized/skilled

personnel may repair/adjust the unit. Use only original parts. For adjustment follow the instructions of

the manufacturer. For further information please contact www.compac.eu