AirTech ACR35-SELV Petunjuk Instalasi dan Pengkabelan - Halaman 5
Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Pengkabelan untuk Kipas angin AirTech ACR35-SELV. AirTech ACR35-SELV 12 halaman.
Display modes
When first powered on, the display will run through an initialisation sequence and then
activate prism mode (cover on).
When a button is pressed, the display will go into the menu system and display as
viewed without the prism.
The display will return to prism mode after 30 seconds of inactivity (i.e. no button
presses).
When activating the menu, the initial button push will not change any settings.
Prism mode may also be re-activated by holding the pull-cord for 5 seconds (if
applicable).
Prism Mode
When the controller is in 'prism mode' the display will be mirrored such that the
characters are shown correctly when viewed through the prism fitted in the fan cover.
When activated, prism mode will run for 15 minutes, first showing the day logger then
cycling between displaying:
Airflow rate (CV model only, other models display speed setting)
Estimated duct pressure (CV model only if CV / F‐2 mode enabled)
Current RH% (HT models only)
Calibration process will run after the first 15 minutes (if CV / F-2 mode enabled); see
Advanced settings for further details.
Menu
If the buttons are pressed the display goes from prism mode to direct view mode and
menu activated. If the buttons are not pressed for 30 seconds the display reverts to
prism mode.
(Up) button is used to increase the value of a
The
setting, the
(Down) button is used to reduce the value
of a setting and the
advance to the next menu item.
The fan has the following 'menu' modes:
Standard (press any button from normal runtime -
Advanced/Engineer (hold
Data-logger readout (hold
(Mode/Set) button is used to
+
for 5 seconds from the standard menu)
for 5 seconds from standard menu)
)