3M W-3197 Petunjuk Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Peralatan Keselamatan 3M W-3197. 3M W-3197 15 halaman. Air regulating kit

W-3197 Air Regulating Kit-low pressure (7-18 psig) Includes:

-W-3255 Connector Assembly, which includes:

-W-3195 Low Pressure Connector

-W-3217 Waist Belt

-W-3187 Airline Adapter

-W-3188 Breathing Tube

-W-3229 Shoulder Strap

-7890 Full Face Plug

Note: W-3253 and W-3255 are not sold separately. You must purchase the appropriate kit or components to

obtain these products.

ASSEMBLY INSTRUCTIONS

These 3M™ Airline Adaptor and Regulating Kits and Breathing Tubes are only used with the 3M™ 7916

Breathing Room Assembly on 3M™ 7000 Series Full Facepiece, 3M™ 6884 DIN Port Adapter on 3M™

6000DIN Series Full Facepiece.

See the 3M™ 6000DIN and 7000 Series Full Facepiece Respirator User's Instructions for information on

installing filters and cartridges.

3M™ Breathing Tube, Belt and Shoulder Strap - Full Facepiece

1. Remove the 7890 plug from the center port of the full facepiece.

2. Install 7890 plugs (7000 Series full facepiece) in each side port, or install 6880 bayonet caps (6000DIN

full facepiece) on each side port. See 6000DIN and 7000 Series User Instructions for installation of filter

or cartridge adapters for use with filters and cartridges.

3. Screw the W-3187 adapter into the center port. Tighten securely so that the threaded fitting points to the

right side of the facepiece, as worn,.

4. Place the belt around the waist, with the female end of the buckle on the right hand side, and adjust for

size and comfort. Slide the plastic belt keeper over any excess belt strap.

5. Unbuckle the belt, and place the sewn loop end of the shoulder strap over the female end of the buckle,

and push the shoulder strap loop onto the belt. The three breathing tube holder loops should face towards

the outside of the belt and the female end of the buckle should be on your right side, as worn.

6. Remove the belt from around the waist.

7. Snap the W-3188 breathing tube into the three breathing tube holder loops on the shoulder strap. (Fig.4)

8. Place the air regulating valve onto the belt just to the left (as pictured) of the shoulder strap sewn strap

loop. (Fig. 4) This will limit the shoulder strap harness from sliding around towards the middle of the

back. Connect the W-3188 breathing tube to the air regulating valve. Assure the connection is tight and

secure.