Electrolux 316488524 Panduan Pemasangan, Penggunaan & Perawatan - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemasangan, Penggunaan & Perawatan untuk Kap Ventilasi Electrolux 316488524. Electrolux 316488524 20 halaman. 30” and 36” free-standing range hood

Halaman Cetak

Electrolux 316488524 Panduan Pemasangan, Penggunaan & Perawatan

Mounting the duct cover bracket

The duct cover bracket should be installed against

the back wall and flush with the ceiling. This bracket

will hold the telescopic duct cover in place at the top

(this a extra accessory available not included with the

hood).

Secur

e the bracket to the wall:

Secure the bracket to the wall:

Secur

e the bracket to the wall:

• Align the marked centerline on the bracket with

the centerline on the wall.

• Mark 2 screw hole locations in the wall.

• Drill 5/16" pilot holes in the marked locations.

• Install wall fastener anchors.

• Drive wood screws, by hand, into the fastener to

allow anchors to expand. Remove the screws.

• Secure the bracket to the wall with wood screws

and/or fasteners.

Ceiling ducting

If the duct will vent straight up to the ceiling:

• Use level to draw a line straight up, from the

centerline on the template to the ceiling.

• Measure at least 4 -3/4 " from the back wall to

the circle center of an 8-½" hole on the ceiling.

W W W W W all ducting

all ducting

If ductwork will vent to rear:

• Use a level to draw a line straight up from the

centerline on the template.

• Measure at least 23 - 3/4" (the measure might

vary dependig on the elbow used) above the

pencil line that indicates the bottom installation

height, to the circle center of an 8-½" diameter

duct hole (Hole may be elongated for duct elbow).

House wiring location

• The junction box is located on the top left side of

the hood.

• Wiring should enter the back wall at least 20"

above the bottom of the installation height, and

within 5-7/8" and 4-7/8"of the left side of the

centerline.

C e i l i

n g

4-3/4" circle

center to wall

Wall

8-1/2" dia. hole

Installing the hood

FOR CEILING VENT DUCTING

Ceiling

FOR

WALL

VENT

DUCT

Circle center at 23 3/4"

above the marked bottom

pencil line.

Horizontal straight

pencil line

9 9 9 9 9