Electrolux 36" Ceramic Panduan Penggunaan dan Perawatan - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Kap Ventilasi Electrolux 36" Ceramic. Electrolux 36" Ceramic 26 halaman. 30” and 36” free-standing range hood
Juga untuk Electrolux 36" Ceramic: Panduan Petunjuk Instalasi (7 halaman), Panduan Pemasangan, Penggunaan & Perawatan (22 halaman), Panduan Petunjuk Instalasi (25 halaman), Panduan Petunjuk Instalasi (8 halaman)

Halaman Cetak

Setting Surface Controls

OPERATING THE DUAL SURFACE RADIANT ELEMENT

med

warm

size

POWER

lock

ON OFF

hot surface

Fig. 1

med

POWER

lock

warm

ON OFF

size

ON OFF

size

ON OFF

hot surface

Fig. 2

4. Select the INNER (Fig. 3) or INNER and OUTER (Fig. 4) to heat by touching the

pad.

5. Touch

MEDIUM, touch

power level to KEEP WARM setting.

6. Each touch of the

the lowest power level available. Note: The power level may be adjusted at any time

Fig. 3

while the element is ON.

7. Start most cooking operations on a higher setting and then turn to a lower setting to finish

cooking. Each surface element provides a constant amount of heat at each setting. A

glowing red surface heating area extending beyond the bottom edge of the cookware

indicates the cookware is too small for the surface heating area.

8. When cooking has been completed touch the

and if no other surface element is used touch the

cooktop.Note: The Hot Surface Indicator Light will turn ON if the cooktop is still

hot and will remain ON until the heating surface area has cooled sufficiently.

Fig. 4

Radiant surface elements may appear to be cooled after they have been turned OFF. The Hot Surface

Indicator Light will turn ON and will continue to glow until the glass cooktop has cooled down to a

moderate level. The glass surface may still be hot and burns may occur if the glass surface is touched

before the indicator light has turned OFF.

Both the 30" and 36" cooktops are equipped with dual radiant surface element

located as shown in Figs. 1 & 2. A touch key pad on the element controls is

used to select one of the 2 positions of the element. Indicator lights on the

control panel are used to indicate which coil of the dual radiant element will

heat. One indicator light on indicates that only the INNER coil will heat (Fig. 3).

Two indicator lights on indicate that both INNER and OUTER coils will heat

(Fig. 4). You may switch from either coil setting at any time during cooking.

To Operate the Dual Surface Element:

timer

1. Place correctly sized cookware on the radiant surface element.

2. Touch and hold the

indicator light above the

touched within 20 seconds the request to Power ON the cooktop will

clear.

3. Touch and hold the

is heard. The indicator light located above the

med

size

timer

Note: If no further pads are touched within 10 seconds the request to

hot surface

power the element ON will clear.

pad once to turn ON the power level to HI. Touch

pad once for power level to LO or touch

CAUTION

UTION

key pad until a beep sound. The power

POWER

will turn ON. Note: If no other key pad is

POWER

pad for the dual element position until a beep

ON OFF

pad will increase or decrease the power level. Lo is

pad once to turn the element OFF

ON OFF

key pad to turn off the

POWER

pad will glow.

ON OFF

key

size

pad once for

med

pad once to set the

warm