Electrolux E:Line ERCE90AS Instalasi dan Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Kap Ventilasi Electrolux E:Line ERCE90AS. Electrolux E:Line ERCE90AS 10 halaman.

Halaman Cetak

4 installation/using the rangehood electrolux e:line rangehood

Installation of outer flue cover

7. You will need to separate the outer and inner flue cover

sections, and carefully peel the protective coating from

both. Additionally, remove the protective coating from

the hood body.

Carefully reassemble the outer and inner flue sections by

sliding the inner flue cover into the outer flue cover.

8. Holding both flue cover sections together, gently slide

the inner flue cover section over the recirculating T-

piece (for recirculating mode) or over the top-flue fixing

bracket (for ducted mode) until the rear edge of the flue

is touching the rear wall.

Carefully lower the outer flue cover section to the top of

the hood body.

9. With filters removed, fix the outer hood section to the

hood body (using the M5x20mm screws supplied) by

fixing through the under side of the hood body.

important

Care must be taken to ensure the screws are not cross

threaded when attaching the outer flue cover.

10. If installed in recirculating mode, insert the optional

carbon filter (not supplied).

11. Replace the aluminium mesh filters. Your Electrolux

rangehood is now ready for use.

Using the rangehood

To switch Canopy ON and OFF

Depress push button 1 to turn the unit ON and depress

push button 1 again to turn the unit OFF.

Setting the power level required

Depress either of the push buttons 2,3 or 4 to select the

desired power required for the type of cooking you are

doing. Confirmation of the level selected is indicated by

the red LED indicator above the selection chosen. Below

is a guide only of the type of cooking being performed and

suggested settings.

setting Low – light frying/boiling

setting Med – frying/wok cooking/heavy boiling

setting Hi

– grilling, intensive frying and wok cooking

To switch Lights ON and OFF

Depress push button 5 to turn the lights ON and depress

push button 5 again to turn the lights OFF. Confirmation of

the light being selected is indicated by the red LED indicator

above the light push button.

Using the Timer

At the end of cooking if the timer is switched on the canopy

rangehood will continue to run for an additional 15 minutes

to remove any odours that remain at the completion of

cooking. After 15 minutes the canopy will turn itself OFF.

Depress push button 6 to turn the timer ON and depress

push button 6 again to turn the timer OFF, if you do not

wish to let it run for the full amount of time. Confirmation

of the timer being selected is indicated by the red LED

indicator above the timer push button.

red LEDs

buttons