Electrolux EFC 639.1 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kap Ventilasi Electrolux EFC 639.1. Electrolux EFC 639.1 14 halaman. Electrolux cooker hood

Halaman Cetak

Using the hood

The hood has one variable speed motor. For the

best performance, we recommend using the low

speeds in normal conditions and the high

speeds in particular cases of strong odour and

vapour concentration.

We recommend starting up the hood a few

minutes before cooking and keeping it running

until all the odours have been eliminated.

5 MIN

1 2 3

E F C D

A – Motor OFF button

B – ON button and motor speed selection

button 1 - 2 - 3 - 1 - 2 - . . . .

E – Speed 1 LED

F – Speed 2 LED and grease filter saturation

LED (flashes)

C – Speed 3 LED and carbon filter saturation

LED (flashes)

D – Intensive speed indicator LED

G – Intensive speed ON switch

This speed should be used when the

concentration of cooking fumes or odours

is particularly strong (for example when

frying, cooking fish etc.).

The fast speed will run for about 5 min-

utes and then return to the speed previ-

ously set automatically (1, 2 or 3), or

switch off if no speed was selected. To

turn off the fast speed, before the end of

the 5 minutes, press button A or button B.

H – OFF lamp button

I – ON lamp button

If the hood fails to operate correctly, briefly

disconnect it from the mains power supply for

almost 5 sec. by pulling out the plug. Then plug

it in again and try once more before contacting

the Technical Assistance Service.

Control devices for the grease

filter and carbon filter

This hood has a device which warns you when

to clean the grease filter or replace the carbon

filter (in the case of the air recircultion version).

This hood is delivered without a carbon filter.

For this reason the warning signal to replace the

carbon filter is not connected.

If the hood will be used for recirculation of air,

with carbon filter, the warning signal have to be

connected as follows: Press the buttons B and G

at the same time for about 3 seconds. The LED

marked F lights up.

When the LED marked C lights up, the warning

signal is connected.

To disconnect the warning signal, press the

buttons B and G at the same time for about 3

seconds until the LED marked C goes out.

Grease filter saturation led

The LED marked F warns you when the grease

filter needs to be cleaned.

This LED flashes to warn you that the grease

filters must be cleaned.

Generally, these must be cleaned after 40 hours

of use.

Read the maintenance instructions provided for

the grease filters.

Carbon filter saturation led

The LED marked C indicates carbon filter needs

to be replaced.

This must be done after approximately 160

hours of use.

Read the instructions provided for replacing the

carbon filter.

To restore the LED for the filter

warnings.

After cleaning of the grease filter and exchange

of the carbon filter, press button A for about 3

seconds until the LED F stops flashing.

Correct ventilation

To have the cooker hood working correctly

the windows in the kitchen should be closed.

In stead a window in an adjacent room

should be open.