Bosch 8 Series Panduan Pengguna dan Petunjuk Instalasi - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Petunjuk Instalasi untuk Kulkas Bosch 8 Series. Bosch 8 Series 28 halaman. Combi steam oven
Juga untuk Bosch 8 Series: Panduan Petunjuk Instalasi (21 halaman), Petunjuk Perakitan (4 halaman), Petunjuk Instalasi dan Penggunaan Manual (16 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna dan Petunjuk Instalasi (44 halaman), Memulai (7 halaman), Buku Petunjuk (32 halaman), Panduan Pengguna dan Petunjuk Instalasi (32 halaman), Buku Petunjuk (12 halaman), Panduan Pengguna dan Petunjuk Instalasi (24 halaman), Panduan Pengguna (28 halaman), Petunjuk Instalasi dan Penggunaan Manual (20 halaman), Panduan Pengguna dan Petunjuk Instalasi (44 halaman), Buku Petunjuk (12 halaman), Panduan Pengguna dan Petunjuk Instalasi (40 halaman), Panduan Pengguna dan Petunjuk Instalasi (32 halaman), Informasi Untuk Penggunaan (20 halaman), Buku Petunjuk (48 halaman)

Halaman Cetak
Bosch 8 Series Panduan Pengguna dan Petunjuk Instalasi
en Troubleshooting
12.1 Malfunctions
Fault
The appliance is not
working.
Appliance does not
start.
The appliance will not
heat up; the
sym-
bol is lit on the dis-
play
The control ring has
fallen out of its sup-
port.
The control ring is dif-
ficult to turn.
The interior lighting is
not working.
16
Cause and troubleshooting
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your room or other appliances are working.
Malfunction
1.
Switch off the fuse in the fuse box.
2.
Switch the fuse back on after approx. 10 seconds.
a If the fault was a one-off, the message disappears.
3.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 17
Appliance door not fully closed.
▶
Close appliance door.
Demo mode is activated.
1.
Disconnect the appliance from power supply by briefly switching off the circuit breaker in
the fuse box.
2.
Deactivate demo mode in the basic settings in the next 3 minutes.
The control ring has come out.
1.
Place the control ring in the support in the control panel.
2.
Push the control ring into the support until it engages and can be turned.
There is dirt under the control ring.
The control ring can be removed.
Note: Do not remove the control ring too often, or the support may become unstable.
1.
To remove the control ring, press down on the outer edge of the control ring.
a The control ring will tilt, making it easier to grasp.
2.
Remove the control ring from its support.
3.
Carefully clean the control ring and its support on the appliance using a cloth and soapy
water.
Do not use harsh or abrasive cleaning products.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
4.
Dry the control ring with a soft cloth.
Interior lighting is defective
▶
Call
→ "Customer Service", Page 17.