Bosch 8 Series Buku Petunjuk - Halaman 15

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kulkas Bosch 8 Series. Bosch 8 Series 48 halaman. Combi steam oven
Juga untuk Bosch 8 Series: Panduan Petunjuk Instalasi (21 halaman), Petunjuk Perakitan (4 halaman), Petunjuk Instalasi dan Penggunaan Manual (16 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna dan Petunjuk Instalasi (44 halaman), Memulai (7 halaman), Buku Petunjuk (32 halaman), Panduan Pengguna dan Petunjuk Instalasi (32 halaman), Buku Petunjuk (12 halaman), Panduan Pengguna dan Petunjuk Instalasi (24 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna dan Petunjuk Instalasi (28 halaman), Petunjuk Instalasi dan Penggunaan Manual (20 halaman), Panduan Pengguna dan Petunjuk Instalasi (44 halaman), Buku Petunjuk (12 halaman), Panduan Pengguna dan Petunjuk Instalasi (40 halaman), Panduan Pengguna dan Petunjuk Instalasi (32 halaman), Informasi Untuk Penggunaan (20 halaman)

Halaman Cetak
Bosch 8 Series Buku Petunjuk
,

Rinse aid

As soon as the low rinse-aid indicator
R i n s e a i d
H is lit on the control panel or is
requested on the front display * )2,
rinse-aid should be topped up.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26°
Clarke, 3.7 mmol/l) only. If the water
hardness is over 21° dH, rinse-aid must
be used.
* depending on the features of your
dishwasher
Top up the rinse-aid as follows:
Open dispenser 9*; press lug on
1.
the lid (1) and lift (2).
Add rinse-aid up to the max. mark.
2.
Close the lid.
3.
Lid "clicks" into position.
Remove overflowed rinse aid with a
4.
cloth.
This prevents excessive frothing
during the next rinse cycle.

Setting amount of rinse aid

The amount of rinse aid to be
dispensed can be set from 0 to 6. Set
the amount of rinse aid to be dispensed
to 5 to obtain a very good drying result.
Do not change the amount of rinse aid
unless there are streaks or water stains
on the utensils. Set a lower level to
avoid streaks. Set a higher level to
avoid water stains.
Set the amount of rinse aid as follows:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button { 8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button > )" until the
4.
rinse aid dispenser is indicated on
the display window at the top @.
Make the setting with setting buttons
5.
+ - P.
Press and hold the Info button {
6.
8 for 3 seconds.
The chosen setting has now been
stored.
Rinse aid en
15