Atlantic 88837 Panduan Produk - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Produk untuk Peralatan Rumput dan Taman Atlantic 88837. Atlantic 88837 4 halaman.

Introduction

Thank you for choosing Atlantic's Eco-Rise wSystem, the fastest and easiest way to create

and plumb any large decorative fountain feature.

The Eco-Rise System is comprised of four elements: ECOBLOX-SMALL structural water

matrix blocks; PV7500 Pump Vault for the pump and accessories; ECORISE12 and

ECORISE20 weight distributing risers that lift and supports heavy items to facilitate

plumbing them and the Eco-Rise Diverter which adjusts the flow to three decorative pieces.

Combined with a pump and liner, these elements create a weight-bearing reservoir that

can deliver water to as many as six individual decorative elements, each weighing up to

3000 lbs.

Reservoir Design And Siting

The size of the reservoir depends on the size, height and number of the decorative fountain

elements. For a general rule of thumb, the basin should extend out at least twice the height

of the decorative elements in all directions. A three-foot-tall by one-foot-wide column

would require a seven-foot splash zone. The Eco-Blox reservoir only needs to be large

enough to support the decorative items. The liner can then be oversized to create a 'splash

skirt' around the basin to recapture as much water as possible with minimum additional

excavation.

Once you have determined the size and shape of the reservoir, lay out the Eco-Blox and

Pump Vault. The Vault should be placed at the perimeter of the excavation where the lid

can be accessed easily, typically closest to the electric service. Make sure the pump cord

will reach.

Excavation & Installation Of Reservoir

After determining the size and shape of the reservoir, excavate at least a foot wider and

longer than required to leave room for backfilling. Excavate the entire area of the basin to a

depth of 13". This will accommodate one layer of Eco-Blox Small plus the gravel to hide the

reservoir. Dig the area where the PV7500 Pump Vault will sit 71/2" deeper to accommodate

it. The additional depth will help ensure the pump remains completely submersed. Level

and tamp the bottom, then cover the bottom and sides with underlayment to protect the

liner, carefully working it into the corners and the deeper Vault area. Set the liner over the

underlayment, leaving the edges above the finished grade all around. An additional layer of

underlayment may be added for greater security.

Set the Pump Vault in the deep pocket, then install the Eco-Blox. The top of the field of

blocks should be level. Pull the liner up snugly without lifting the blocks and fold it over

the top of the Eco-Blox, then do the same with the underlayment. Backfill evenly all the

way around the blocks in 6" lifts, tamping the soil in as you go, being careful not to push

the Eco-Blox out of place, until the fill reaches the top of the blocks. Grade outside of the

reservoir to create a bowl that will return splash to the reservoir. Creating a slight berm at

the outer edge of the bowl will keep runoff from entering the basin.