Atlantic SP1600 Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Rumput dan Taman Atlantic SP1600. Atlantic SP1600 16 halaman. Oasis series skimmer, filterfalls, pump vault, fastfalls
Juga untuk Atlantic SP1600: Panduan Produk (12 halaman)

Halaman Cetak

1. Setting the Bf1600

Once you have placed the unit, make sure it is level from side to side and check the level

from front to back. FilterFalls should always be installed tilted slightly forward about ¼".

This will ensure that water never leaks out over the back of the enclosure. When you are

finished positioning the unit, it is a good idea to weigh it down with a few rocks to keep it

in place while you backfill and make your liner and plumbing connections. Apply silicone on

the threads of the Male Thread Adaptor (MTA). Screw the MTA into the bulkhead until tight.

Use PVC Glue (not included) to glue the PVC flex hose into the MTA.

Do not completely backfill the FilterFalls until all of your plumbing connections

are made and the liner has been attached.

LINER ATTACHMENT

Atlantic FilterFalls come equipped with a solid spillway, threaded inserts and a 'U' shaped

wrap-around flange to provide the best possible seal.

Start by positioning the liner. Pull the liner up the face of the FilterFalls and drape a minimum

of 6" of liner over the top of the enclosure. Use the provided spring clips to temporarily hold

the liner in place (Figure 10). Leave some excess slack in the liner below the spillway. This will

help to alleviate any future strain on the liner connection. With the liner firmly in place, use a

sharp razor knife to cut the spillway opening in the liner using the inside of the spillway as a

guide (Figure 10).

Remove the spring clips and pull the liner away from the face of the enclosure. Make sure

that the front of the FilterFalls and the back side of the liner are clean and free of debris.

Apply a consistent bead of Atlantic fish-safe silicone to the face of the FilterFalls along the

center line of the threaded inserts.

Return the liner to the face of the FilterFalls and hold it in place by attaching the spring clips

to the rolled lip on either side of the spillway (Figure 11).

Figure 10.

Figure 11.