Atlantic 73898 Panduan Produk - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Produk untuk Pompa Air Atlantic 73898. Atlantic 73898 17 halaman.

Halaman Cetak

Introduction

Thank you for choosing this Atlantic TidalWave L-Series pump. Before using this pump

please take a moment to review this manual.

To avoid an accident do not use the pump in any way other than as described in this

manual. Please note the manufacturer cannot be responsible for accidents arising because

the product was not used as prescribed. After reading this manual keep it as a reference in

case questions arise during use. Using the pump in a manner that is not prescribed will void

the warranty.

MODEL

MAX FLOW

L-305

11400

L-310

14200

Recommended Operating Range

Prior to Operation and Installation

When the pump is delivered, first perform the following checks:

• Check for any damage to pump and power cable that may have occurred during

the shipment.

• Check the model number to make sure it is the product that was ordered and verify the

voltage and frequency are correct.

Caution

• DO NOT operate this product under any condition other than those for which it is specified.

Failure to observe this precaution can lead to electrical shock, electrical leakage, fire, water

leakage or other problems.

• L-305/L-310 pumps require a single phase 115 volt / 60 hz power supply. Always verify that

the supplied power meets the requirements listed on the upper pump cover.

• DO NOT apply any paint over the stainless steel motor body. Reduced cooling ability will

result in overheat, overload, introduce undesirable performance reductions, periodic auto

shut-off and pump malfunction.

• Never place your hand or any object in or near the inlet opening while this equipment

is operating. If pump inlet is clogged, always turn off the power supply, fuse box or circuit

breaker and wait until the motor is completely stopped before attempting to remove any

clogged material.

• Please make sure that the power plug and the AC outlet receptacle is protected and away

from water or pump discharge hose to prevent accidental electric shock or short circuit.

• Always operate the pump completely submerged in water.

• Avoid dry operation, which will not only lower performance but can cause the pump to

overheat/malfunction, leading to electrical leakage, shock or premature failure.

• CAUTION:

THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.

• ATTENTION:

CETTE POMPE DOIT ETRE BRANCHEE A UNE DERIVATION PROTEGEE PAR UN

DISJONCTEUR DIFFERENTIEL.

• CAUTION:

THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

10'

10380

7380

13500

10560

Best Efficiency Range

15'

20'

3960

7380

3240

Do Not Operate Range

25'

30'