Atlantic SH2050 Panduan Pengoperasian - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pompa Air Atlantic SH2050. Atlantic SH2050 13 halaman.

Introduction

Thank you for selecting the TidalWave SH1450, SH2050, SH3600, SH5000, or SH6500

series pumps. Before using this pump please take a moment to review this manual.

To avoid an accident do not use the pump in any way other than as described in this

manual. Please note the manufacturer cannot be responsible for accidents arising because

the product was not used as prescribed. After reading this manual keep it as a reference

in case questions arise during use.

Flow

Chart:

(GPH)

Best Efficiency Point

Prior to Operation and Installation

• Check for any damage to pump and power cable that may have occurred during

the shipment.

• Check the model number to make sure it is the product that was ordered and verify

the voltage and frequency are correct.

Caution

• DO NOT operate this product under any condition other than those for which it is

specified. Failure to observe this precaution can lead to electrical shock, electrical

leakage, fire, water leakage or other problems.

• The pump is a 100/120 volt 60 Hz pump, please only use with a power supply voltage

within 100-120 volt 60 Hz.

• Never place your hand or any object in or near the inlet opening while this equipment is

operating. If pump inlet is clogged, always turn off the power supply and wait until the

motor is completely stopped before attempting to remove any clogged material.

• Please make sure that the power plug and the AC outlet receptacle is protected and away

from water or pump discharge hose to prevent accidental electric shock or short circuit.

• Always operate the pump completely submerged in water.

• Avoid dry operation, which will not only lower performance but can cause the

pump to overheat/malfunction, leading to electrical leakage, shock or premature failure.

• CAUTION: THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND

CIRCUIT INTERRUPTER.

• CAUTION: THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

• WARNING:RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING

CONDUCTOR AND GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK

OF ELECTRIC SHOCK, BE CERTAIN THAT IT IS CONNECTED ONLY TO A PROPERLY

GROUNDED RECEPTACLE.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with

all applicable safety regulations. Incorrect wiring can lead to a pump malfunction,

electrical shock or fire.

Recommended Operating Range

Do Not Operate Range