Atlantic TidalWave TT1500 Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pompa Air Atlantic TidalWave TT1500. Atlantic TidalWave TT1500 17 halaman.

Cleaning

TidalWave TT-series pumps require periodic cleaning of the stainless steel cooling screen,

rotor and rotor chamber. Please follow the directions below for proper cleaning procedures:

• Unlock the latches on either side of the pre-filter by pulling outward from the pump

handle. Slide the pre-filter off to expose the volute.

• Remove the volute by rotating counterclockwise one quarter turn while pulling lightly

outward from the pump body. The TT9000 will require the removal of five screws to

remove the volute.

• Inspect the intake O-ring for nicks or breaks.

• Inspect the impeller and remove any debris that may be present.

• A stainless steel screen located behind the impeller draws water in to cool the rotor. If

the screen becomes blocked the pump may overheat. Inspect the screen and remove any

accumulated debris.

• Spin the impeller. If the impeller is difficult to turn, feels "gritty", or a grinding noise is

evident in the rotor chamber, remove the rotor as per the instructions below.

Removing the rotor

The rotor must be unlocked using the built-in wrench located on the bottom of the pre-filter

before it can be removed from the rotor chamber. Slide the impeller wrench behind the

impeller and engage two of the locking posts located on the face of the rotor. Push the

wrench tightly against the rotor face and rotate counterclockwise one quarter turn. Once

unlocked, remove the rotor by pulling the impeller outward from the pump body.

• Inspect the stainless steel rotor and the rotor chamber for built up debris. Loose debris

can be flushed out with clean water. Often in hard water, well water

or pond-free applications, debris may appear as a crusty film

around the rotor and in the rotor chamber.

Remove this film using a scrub brush

and white vinegar.

• Slide the rotor into the rotor

chamber and lock it in place

by rotating clockwise

one quarter turn.

• Attach the volute by

applying pressure and

rotating clockwise

one quarter turn.

• Replace the pre-filter

and lock the latches.