2 Save Energy OWL intuition-c Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Ketel uap 2 Save Energy OWL intuition-c. 2 Save Energy OWL intuition-c 16 halaman. Room sensor [rbt-3c] with network owl

Halaman Cetak

12.

Battery Replacement

The Room Sensor runs on 2 x AAA size Alkaline non recharge-

able batteries and depending upon usage is designed to give

a battery life of approximately 12 to 18 months. Through the

OWL Intuition web dashboard you can see the current battery

level for the Room Sensor at any time. When the batteries are

nearing the end of their life the battery symbol will turn red

and you will get a message pop-up each time you log in to

warn you. As a final warning the Away LED will start to flash

on/off every second. When you see one of these warnings you

should replace the batteries as soon as possible.

To change the batteries it is necessary to remove the Room

Sensor from the wall.

Undo the two captive screws at the base of the Room

Sensor and swing the Room Sensor out at the bottom

then up and away from the backplate.

Remove the old batteries and replace them with two new

high quality, high capacity AAA size Alkaline batteries, en-

suring that they are fitted correctly as indicated by the diagram below. Note they both

face in the same direction.

check that the battery level indicator is now fully

green (100%).

5. IMPORTANT: If the batteries are allowed to

get too low the heating will no longer be able

to switch on. This could be a risk for elderly

and infirm householders.

3. Once the batteries are fitted, re-fit

the Room Sensor to the backplate by

engaging with the lugs at the top of

the backplate, then carefully swing

the Room Sensor down and push it

carefully back into its plug-in terminal

connectors. Locate over the captive

screws at the base of the backplate

and tighten them so that the Room

Sensor is locked into position.

Captive Screws

Locating Lugs