Atlantic Ultraviolet 10-0508B Panduan Pemilik - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air Atlantic Ultraviolet 10-0508B. Atlantic Ultraviolet 10-0508B 20 halaman. Germicidal ultraviolet water purifiers
Juga untuk Atlantic Ultraviolet 10-0508B: Panduan Pemilik (16 halaman)

Halaman Cetak

4. As with any water purifier installation, routine maintenance is necessary to insure your equipment is operating correctly.

Regular inspection must also include the inspection of the ground to insure grounding wires are secure to both the water

purifier and grounding point as originally installed. Regular inspection must also include confirmation that approved ground

fault circuit interrupt (GFCI) receptacle is still operational and that water purifier is plugged into this GFCI. Any components

which are damaged, or broken should be replaced.

AMP

NSTALLATION OR

.10-0508B

USING BALLAST NO

Figure 7 - Lamp Replacement

Step 2 - Remove End-Cap

SAFETY EQUIPMENT REQUIRED TO PERFORM TASK

WARNING: Disconnect power to water purifier, and remove ground connector from the chamber.

2. Remove EASY-OFF

3. Pull lamp cord and carefully withdraw lamp approximately 2 inches from chamber. While holding lamp end, remove lamp

socket from exposed lamp end.

4. Carefully withdraw lamp from chamber. Be sure to withdraw lamp straight out without angling until completely

clear of quartz sleeve.

CAUTION: Lamp and quartz sleeve are easily damaged. Exercise care when handling.

5. Reinstall lamp in reverse order.

WARNING: Germicidal ultraviolet rays are harmful to eyes and skin. Do not restore power to water purifier until

lamp and both EASY-OFF

MIN-6

EPLACEMENT

Step 3 - Remove Socket

end cap by pulling cap off static gland nut.

end caps have been properly reinstalled.

MIN-9 120

50/60H

AND

Step 1 - Disconnect Power to Water

Purifier and Remove Ground Connector

Step 4 - Remove Lamp