Electrolux PLHV42P8CC Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Kap Ventilasi Electrolux PLHV42P8CC. Electrolux PLHV42P8CC 32 halaman. Range hood
Juga untuk Electrolux PLHV42P8CC: Panduan Pemilik (32 halaman), Panduan Pemilik (11 halaman), Panduan Pemilik (32 halaman), Panduan Pemilik (10 halaman)

Halaman Cetak
Electrolux PLHV42P8CC Panduan Pemilik
Installation
Wiring to Power Supply
Figure I 0
Top
chimney-to-structure
fixing point
.
,,
.,.
WARNING!
ELECTRICAL GROUNDING INSTRUCTIONS
THISAPPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH
3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE.
TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE
GREEN AND YELLOWWIRE MUST BE CONNECTED TO THE GROUNDING
WIRE INYOUR
HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES
BE CUT OR REMOVED.
Warning: Turn off power circuit atthe service panel beforewiring
this unit.
120 VAC, 15 or 20 Amp circuit required.
16. Remove j-box coverasshown
in Figure 10.
17. Remove the knockout and install the strain relief (conduit) connector (1/2") in
junction box.
18. Run 3 wires; black, white and green (#16AWG)in
1/2" conduit from service panel
to junction box.
19. Connect black wire from service panel to black or red in junction box, white to
white and green to green-yellow. See Figure 10.
20. Close junction box cover, check all light bulbs to make sure they are secure in
their sockets, then turn power on in service panel and check lights and blower
operation per Care & Use section of this manual and install filters.
Final assembly
For final
Chimney
Cover
installation,
DO NOT USE ELECTRIC SCREW
DRIVER.
rear
Chimney
21.
cover
22.
23.
Fit the nuts with fixing hooks supplied inside the top and bottom sections of the
chimney covers at all the rectangular slots. Figure 11-12.
Join the two top sections of the chimeny covers to cover the chimney structure.
Screw the two sections together with 4 screws (2 each side- see the plan
diagram for joining the two sections). Figure 11.
Fix the covers to the structure, near the ceiling, with two screws (one each side).
Figure 11.
Figure 11