Electrolux UltimateTaste 500 Buku Instruksi - Halaman 6

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Kap Ventilasi Electrolux UltimateTaste 500. Electrolux UltimateTaste 500 20 halaman. High power blender
Juga untuk Electrolux UltimateTaste 500: Buku Instruksi (21 halaman), Buku Instruksi (24 halaman), Buku Instruksi (12 halaman), Buku Instruksi (16 halaman), Buku Instruksi (16 halaman), Buku Instruksi (26 halaman), Panduan Pengguna (22 halaman), Panduan Pengguna (23 halaman), Panduan Pengguna (16 halaman), Panduan Pengguna (23 halaman), Buku Instruksi (24 halaman)

Halaman Cetak
Electrolux UltimateTaste 500 Buku Instruksi
17 Decalcifying is recommended regularly, depending on water hardness. Fill the kettle with water and
EN
EN
decalcifier according to decalcifier product instructions. Do not boil the solution as it may foam over.
Afterwards, rinse kettle thoroughly with fresh water.
CNS
Enjoy your new Electrolux product!
CNT

TROUBLESHOOTING

KR
PROBLEM
TH
The appliance switches
off before boiling.
The appliance keeps
heating up water and
does not switch off.
The appliance cannot
be switched on.
The display shows "E3"
error code.
Kettle alarm, "START"
button light flashing.
Water temperature is
lower than the
setting.
DISPOSAL
Recycle the materials with the symbol
protect the environment and human health and to recycle waste of electrical and electronic appliances.
Do not dispose appliances marked with the symbol
your local recycling facility or contact your municipal office.

CUSTOMER CARE AND SERVICE

When contacting Service, ensure that you have the following data available: Model, PNC, Serial Number.
The information can be found on the rating plate.
Due to the Electrolux policy of continual product development; specifications, colours, and details of our
products and those mentioned in this manual are subject to change without notice.
www.electrolux.com
POSSIBLE CAUSE
Too much lime scale at the base
of the kettle.
The thermostat overheated.
The NTC is short-circuited or
disconnected.
Temperature sensor could be
covered with dirt if the kettle has
been misused to warm food or
other beverages.
Under TURBO program, water
volume is more than 200ml.
. Put the packaging in applicable containers to recycle it. Help
SOLUTION
Run the decalcifying procedure.
Close lid until it locks
Insert the strainer correctly.
Allow the kettle to cool down and try again
later.
Turn off the machine to cool down or add
water again.
Return the machine to service center.
Clean temperature sensor, a pin shaped
part, located at the bottom of inner kettle
tank.
Under TURBO program, water volume has
to be less than 200ml.
with the household waste. Return the product to
6