Electrolux Vent Hood Petunjuk Pemasangan Manual Penggunaan & Perawatan - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan Manual Penggunaan & Perawatan untuk Kap Ventilasi Electrolux Vent Hood. Electrolux Vent Hood 16 halaman.

Halaman Cetak

Installation

Connect ductwork

(DUCTED HOODS ONLY)

1. Use 6" round metal duct to connect the discharge

collar on the hood to the ductwork above (Fig. 11).

2. Use duct tape to make all joints secure and air tight.

3. Remove the tape from the lower flue and set it in

place on the hood (Fig. 11).

Install filters

(DUCTED AND NON-DUCTED HOODS)

1. To remove the GREASE filters, pull the metal latch

tab outside and unlock the filter.

2. To install the GREASE filters, align rear filter tabs

with slots in the hood. Depress the metal latch tab,

push filter into position and release. Make sure

filter is securely engaged after installation.

NOTE

Prior to use, remove protective film from the

TAPE

filter frame.

(NON-DUCTED HOODS ONLY)

1. To remove the CHARCOAL filter, push in on the

front filter latch. Pull the filter down to disengage

6" ROUND METAL

the rear filter tabs.

DUCT

2. To install the CHARCOAL filter, align the rear filter

tabs with slots in the hood. Push the filter up into

place until the front latch snaps securely into the

slot. Make sure the filter is securely engaged after

assembly.

3. Install GREASE filters after charcoal filter is in-

FIG.11

stalled.

GREASE FILTERS

TABS

NON-DUCTED

RECIRCULATION

LATCH

FILTER