Electrolux WEGL1030CN Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kap Ventilasi Electrolux WEGL1030CN. Electrolux WEGL1030CN 48 halaman.

Halaman Cetak

6. CONTROLS

The hood can be switched on pushing directly onto the requested speed

without firstly having to select 0/1 button.

Basic function

Button

Dual Function

Press briefly to turn the lighting system on and off.

Press and hold the button for 2 seconds to activate

the lighting system in "courtesy light" mode. The lights

are lit at a reduced power of approximately 5W. This

function can be disabled by pressing the button once

again for 2 seconds or by pressing it briefly to switch

to normal lighting mode.

Turns the motor off from whatever speed it is set to.

Press and hold the button for 3 seconds with all

the loads turned off (Motor and Lights), to turn the

Activated Charcoal Filter alarm on/off.

Turns the motor on at speed one.

When pressed briefly, turns the motor on at speed

two.

Press and hold the button for approximately 2" to turn

the Delay function on and off, that is to say to turn

the appliance off after a 20 minute delay. Suitable to

complete elimination of residual odours. Can be acti-

vated from the OFF position and from speeds 1, 2, 3.

Cannot be activated with Intensive speed On.

Turns the motor on at speed three.

Turns the motor On and Off at Intensive speed for

a timed period of 5 minutes. At the end of the 5

minutes the appliance will automatically return to

the speed that was set before. If the appliance was

turned off at the time of activation, at the end of the 5

minutes the system will return to speed one.

Press and hold for 4 seconds to reset the filter alarm

indicator, shown by flashing of button T1. This proce-

dure can only be carried out with the motor off.

L T1 T2 T3 T4 T5 F

Indicator lights

Button off

Lights off

Button lit

Lights on

Button lit

Courtesy light on

Button lit

Motor active

Motor inactive

Button flashes twice F – Alarm On.

Button flashes once F – Alarm Off.

Button on

Speed two on

Buttons flash-

ing (T1+T2 or

Delay functionActive

T3 or T4)

Button on

Signals the Metal Grease Filter

saturation alarm, indicating that it

is necessary to wash the filters.

Button on

The alarm is triggered after the

Hood has been in operation for

100 working hours.

When this is activated, it signals

the Activated Charcoal Filter

saturation alarm, indicating that

the filter must be changed; the

Button

Metal Grease Filters must also be

flashing

washed. The Activated Charcoal

Filter saturation alarm comes

into operation after the Hood has

been working for 200 hours.

ENGLISH