ADVANCED Network Devices IPSWD-RWB Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Pembicara ADVANCED Network Devices IPSWD-RWB. ADVANCED Network Devices IPSWD-RWB 2 halaman.

Halaman Cetak

Device Operation

1. Connect the other end of the network cable to a PoE (Power over Ethernet) network switch, or a

PoE injector, on a network with a DHCP server. Some equipment options are listed on the

support site: www.anetdsupport.com/peripherals.

2. If properly installed, the unit should boot and show the time within 30 seconds. See Boot

Sequence below for details.

3. Consult the

Clockwise User manual

software guide for further instructions on sending audio and text to the device.

Boot Sequence

When first powered, if properly installed, the device should boot and then display the time, as

follows:

IPSWD/IPSWD-RWB

Installation Instructions

(see www.anetdsupport.com/documents) or 3

This is the 1st screen seen, and you will hear the AND

jingle during it. This screen should come on within 1-2

seconds of powering on the device.

This indicates the current firmware the device is

equipped with.

The network MAC address of the device. This is

configured at the factory.

The device is now looking for a DHCP server among

other things.

chance there is a network problem (cable, switch, ISP,

DHCP,

The IP address of the device. This is network specific,

and depends what DHCP assigns it or static if configured

as such. You should hear an audio beep during this

stage.

Once all initialization is done, the time will be displayed.

If just a colon is displayed, it is alive, but cannot find the

time. Check the NTP server settings and check that the

Internet connection is working.

For additional support, visit

If it hangs in this state, there is a good

etc.).

www.anetdsupport.com

Version 1.4

party