Drill Master 61204 Panduan Pemilik & Petunjuk Keselamatan - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pemilik & Petunjuk Keselamatan untuk Melihat Drill Master 61204. Drill Master 61204 16 halaman. 120 volt 6" cut-off saw
Juga untuk Drill Master 61204: Panduan Pemilik dan Petunjuk Keselamatan (16 halaman)
Halaman Cetak
Work piece and Work area Set up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
using the Vise
Secure loose work pieces using the Vise to prevent
movement while working: See Figure E.
1. Turn the Vise Knob counterclockwise a
quarter turn and lift up the Quick Release.
2. Slide the Vise Clamp open as far as needed.
3. Position the workpiece against the Angle Guide.
4. Push the Quick Release down onto the Vise threads.
5. Push the Vise Knob until the Vise Clamp
is up against the workpiece.
6. Tighten the Vise Knob clockwise
to secure the workpiece.
General Operating instructions
cautiOn! Friction from cutting will heat both the Wheel and the workpiece. Be careful when handling the
workpiece and do not overwork the Cut-Off Saw as the Wheel can become damaged from overheating.
1. Release the Safety Chain and guide the
Housing to rest at its full upward position.
2. Adjust the Angle Guide as needed.
3. Place the workpiece against the Angle Guide
and clamp in place using the Vise.
4. Plug the Power Cord into a grounded,
120VAC electrical outlet.
5. Press the Safety Button, then squeeze and
hold the Trigger to start the Saw. Allow the
Grinding Wheel to attain full speed.
61204
For technical questions, please call 1-888-866-5797.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Quick
Vise
release
clamp
Vise
Knob
Figure E: Vise components
6. With one hand on the Handle and the other hand
clear, slowly bring the Saw down, letting the Saw
do the work. Do not apply excessive force.
7. After making the cut, release the
Trigger and raise the Saw.
8. Wait until the Wheel comes to a complete
stop, then remove the workpiece.
9. To prevent accidents, turn off the tool and
disconnect its power supply after use. Lower the
Saw and secure with the Safety Chain. Clean,
then store the tool indoors out of children's reach.
angle
Guide
Page 9