Drill Master 61311 Panduan Pemilik & Petunjuk Keselamatan - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pemilik & Petunjuk Keselamatan untuk Sander Drill Master 61311. Drill Master 61311 12 halaman. 120 volt orbital hand sander
Halaman CetakGeneral Operating instructions
1. Make sure that the Switch is in the
off-position, then plug in the tool.
2. Turn on the Switch.
3. Run the Sander for a few seconds
before contacting the workpiece.
4. Contact the workpiece with minimal pressure.
Use sandpaper with a lower grit number
to remove material faster.
Item 61311
For technical questions, please call 1-888-866-5797.
note: All orbital sanders leave sanding marks
on the workpiece. To minimize sanding marks,
always try to sand with the grain of the wood.
5. Occasionally check the sandpaper for tears,
wear, or fraying. Replace if necessary.
WarninG! The tool will restart automatically if stalled.
6. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children's reach.
Page 9