Atlas F6-MF Panduan Pemilik - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Atlas F6-MF. Atlas F6-MF 16 halaman. Multi-impedance modular amplifier
Juga untuk Atlas F6-MF: Panduan Pemilik (3 halaman)

Halaman Cetak
Atlas F6-MF Panduan Pemilik
Owner's Manual
Placement of the F6
Turn off all equipment before making connections. Mount the F6-MF in a standard width 19" rack. It can be mounted above or below
anything that does not generate excessive heat. Although the unit's chassis is shielded against radio frequency and electromagnetic
interference, extremely high fields of RFI and EMI should be avoided.
Ventilation
The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the F6-MF should
not be situated in a sealed cabinet or on a shelf with obstacles on it that may impede the flow of air through the ventilation openings. It
is recommended that if the amp is not used in an open air pole mount that it be rack mounted into a commercial rack.
Heat
The F6-MF should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including
amplifiers) that produce excessive heat. Ambient temperatures should not exceed 113°F (45°C) when equipment is in use.
Cabling of the F6
The F6-MF can be used with either balanced or unbalanced sources, and the outputs can be used with either balanced or unbalanced
loads provided the proper cabling is used. A balanced line is defined as two-conductor shielded cable with the two center conductors
carrying the same signal of opposite polarity when referenced to ground. An unbalanced line is generally a single-conductor shielded
cable with the center conductor carrying the signal and the shield at ground potential.
Balanced Input
Use 2 conductor wire shielding for low level signals, 20 to 22 gauge is best. Maintain the proper polarity, + to +, – to –, and shield to
ground. Note: The ground center pin of the Phoenix connector is common for both channels.
Speaker Outputs
Use 2 conductor unshielded wire of the appropriate gauge. If you are unsure about this, contact Atlas Sound Tech Support at
1-800-876-3333. Make sure you know how many speakers you need and what tap value you intend to use.
Multi-Impedance Modular Amplifier
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
– 13 –
Specifications are subject to change without notice.
F6-MF
AtlasSound.com