Atlas Diane AC-MGB2 Petunjuk Manual - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Kipas angin Atlas Diane AC-MGB2. Atlas Diane AC-MGB2 9 halaman. Ceiling mounted oscillating directional fan ac 120v. 60hz

Halaman Cetak
MOUNTING/INSTALLATION
OF THE FAN
Before touching a screw driver thoroughly
read these instructions.
Warning/Caution:
off power at service panel and check all visible
screws and bolts for tightness.
1. Remove
the decorative
cover from the canopy by turning the cover
counter clockwise. (Fig. 5)
2. Remove the hanger bracket from the canopy
by removing the 1 of 2 screws from the bottom of
the hanger bracket and loosening the other one a
half turn from the screw head. Next, turn the
canopy counter
clockwise
hanger bracket from the canopy. (Fig, 5)
3. Secure the hanger bracket to the ceiling
outlet box using screws and washers included
with your outlet box. (Fig. 6)
4.
Remove
hanger
assembly by loosening set screws, removing
the cross pin and sliding ball off rod. (Fig. 7)
SA. Metal Blade Head and Decorative Cage:
If your fan is one with a metal blade head and
decorative
cage,
remove
sleeve from the motor shaft, and then attach
the metal blade head and cage. The Atlas
medallion
should
Handle your blade head carefully otherwise
you will bend the blade irons and cause your
fan to vibrate when in use. Caution: The set
screw
in the
blade
counter-sunk
into
flattened side of the motor shaft - or else the
blade head may disengage from the motor
shaft during operation.
5B. Metal Blade Head and Safety Cage: If
your fan is one with a metal blade head and
safety cage, remove protective plastic sleeve
from the motor shaft, then and attach the back
side of the safety cage. Next, attach the blade
head.
Handle
your
otherwise you will bend the blade irons and
cause your fan to vibrate when in use. Finally
attach the front side of the cage with Atlas
medallion oriented correctly. Caution: The set
screw in the blade hub must be counter-sunk
into the bore-hole on the flattened side of the
motor shaft - or else the blade head may
disengage
from
operation.
Before installing fan, turn
canopy
bottom
to removing the
ball
from
down
protective
be oriented
correctly.
head
hub
must
the
bore-hole
on the
blade
head
carefully
the
motor
shaft
rod
Hanger ....-..~
ball
plastic
be
during
4
i\1~.:.' !
VC-~:~~ne~
•
i
~,\~::!
= o=' !
)~ceiling
~
:
•
(~+---canopy
Figure 5
120VWires
Figure 6
.--Cross
pin
~
..
fl~"rnw
~
~
Downrod
Figure 7
Allen set screws
/
--------------1.-
Figure 8
bracket
canopy
cover
~~:~Ch