Atlas Copco AME 1600 Manual Petunjuk Keselamatan dan Pengoperasian - Halaman 11

Jelajahi secara online atau unduh pdf Manual Petunjuk Keselamatan dan Pengoperasian untuk Alat Listrik Atlas Copco AME 1600. Atlas Copco AME 1600 20 halaman. Poker vibrator

Halaman Cetak

1. Machine Data

AME 1600

Connect the shaft on the drive unit

1. Lift the locking piston (A) on the drive unit (D).

2. Insert the ﬂ exible shaft (B) into the hole in the

drive unit.

3. Make sure that the square ﬁ tting of the ﬂ exible

shaft (C) ﬁ ts the square tube on the drive unit

(D).

4. Secure the vibrator tube to the ﬂ exible shaft by

screwing it with left-hand

5. Plug the drive unit (D) into the power socket

and start the machine.

Vibrating

NOTICE Never use the poker vibrator to move

the concrete sideways.

1. Allow the vibrator to penetrate about 15 cm (6

in.) down into the nearest lower layer to ensure

that the various layers merge well with each

other.

2. Fill the concrete evenly in the form work in 30 -

50 cm (12 - 19 in.) layers.

30-50 cm

(11-19 in.)

Original instructions

3. Insert the poker vibrator vertically at a distance

4. Vibrate systematically.

5. Slowly withdraw the vibrator to allow the

6. The concrete is thoroughly vibrated when the

When taking a break

♦

30-50 cm

(11-19 in.)

15 cm

(6 in.)

Safety and operating instructions

of 8-10 times the tube diameter between

insertions.

concrete to reﬁ ll the cavity left by the vibrator.

area around the vibrator turns shiny and no air

bubbles rise to the surface. This will normally

take about 10-20 seconds.

During all breaks you must place the machine

in such a way that there is no risk for it to be

unintentionally started. Make sure to place the

machine on the ground, so that it can not fall.

Switch off the power supply in the event of a

longer break or when leaving the workplace.