Bose 865983-0500 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Pembicara Bose 865983-0500. Bose 865983-0500 38 halaman.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the product.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Bose Corporation could void the user's authority to operate

this equipment.

This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause undesired operation of the

device.

This device complies with FCC and ISED Canada radiation exposure limits set forth for general population.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Meets IMDA Requirements.

The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/EC and

the Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020, is in

compliance with the following norm(s) or document(s): Regulation (EC) No. 1275/2008, as amended by Regulation

(EU) No. 801/2013.

Required Power State Information

Power consumption in specified power mode, at

230V/50Hz input

Time after which equipment is automatically

switched into mode

Power consumption in networked standby if all wired

network ports are connected and all wireless network

ports are activated, at 230V/50Hz input

Network port deactivation/activation procedures.

Deactivating all networks will enable standby mode.

CAN ICES-3(B)/NMB-3(B)

For Europe:

Frequency band of operation 2400 to 2483.5 MHz.

Maximum transmit power less than 20 dBm EIRP.

This symbol means the product must not be discarded as household waste, and should be delivered to an

appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources,

human health and the environment. For more information on disposal and recycling of this product, contact

your local municipality, disposal service, or the shop where you bought this product.

R EG U LATORY A N D L E G AL I NFO RM AT I O N

Standby

< 0.5 W

≤ 20 minutes

N/A

Bluetooth: Deactivate by clearing the pairing list by pressing and

holding the Bluetooth button for 10 seconds. Activate by pairing with a

Bluetooth source.

E N G

Power Modes

Networked Standby

Bluetooth < 2.0 W

≤ 20 minutes

< 2.0 W