Bose 901 Panduan Pemilik - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembicara Bose 901. Bose 901 20 halaman. Vi direct/reflecting speaker system
Juga untuk Bose 901: Panduan Pemilik (41 halaman), Panduan Pemilik (23 halaman), Petunjuk Perakitan dan Pemasangan (1 halaman), Panduan Pemilik (12 halaman), Panduan Pemasangan dan Pengoperasian (15 halaman)

Connecting the speakers to the

receiver

Make sure the terminal knurled nut is tightened down ﬁrmly. Any gap between the wire and

terminal can cause heat build up. Check to be sure the wires are connected positive to posi-

tive (+ to +) and negative to negative (- to -). Make sure no loose strands of wire touch across

terminals, which can cause short circuits.

There are two options for connecting the equalizer. Your choice depends on the type of

receiver you own and whether you plan to use the system primarily for stereo or for home

theater enjoyment.

The Bose

901

active equalizer connects directly to your receiver through the tape monitor

connection. If your receiver has more than one tape connection, use the second one (TAPE 2).

To connect a tape deck, use the additional set of inputs and outputs located on the back of the

901 active equalizer marked TAPE RECORDER CONNECTIONS.

The TAPE MONITOR switch on the front of the receiver lets you switch the equalizer in and out

of the signal path. This is important when you want to play conventional, non-equalized speak-

ers or headphones attached to your receiver. See Using other equipment on page 13.

If your receiver is designed for home theater use, it may not have a Tape Monitor switch.

If not, you must use a PRE AMP OUT/MAIN AMP IN connection. This may also be called the

ADAPTER or SIGNAL PROCESSOR connection. Refer to "Home theater use (PRE AMP OUT/

MAIN AMP IN)" on page 10 for instructions on how to connect for home theater use.

1. Disconnect any external tape deck or signal processor connected to the tape monitor

connection.

2. Use the twin cable assemblies (with two connectors at each end) that are supplied with

the equalizer. Use the red connector for the right (R) channel connections and the other

connector for the left (L) channel connections.

Receiver

+ –