Atlas Copco PHE 3 Instruksi Perbaikan - Halaman 12
Jelajahi secara online atau unduh pdf Instruksi Perbaikan untuk Bor Atlas Copco PHE 3. Atlas Copco PHE 3 14 halaman.
Mounting the
1 Insert the two disks (3) and the bolt (4)
back gear shaft
into the cylinder (2).
and the cylinder
2 Insert the rolls (6) into the back gear shaft
one after the other and fix it with grease.
cage (from date of manufacture 09/97).
3 The back gear (7) can only be inserted as
follows:
– Put together the cylinder and the back
– Turn the tumble drive to the lowest
– insert the cylinder into the end shield
– Insert the tumble drive into the
4 Grease the striker (1) and insert it into the
cylinder.
Mounting the
1 Press the bearing ring (1) into the
spindle bearing
bearing housing (2).
2 Insert the bearing housing (2) into the
motor housing (do not yet insert it
completely, mind the right position).
3 Press in the bearing housing (2) as far as it
will go.
Assembling the
spindle
spindle is provided with service borings
(mounting the
for easy removing of the locking ring (7).
inner parts)
Older spindles must be exchanged for
only applicable
new ones.
for PHE 3
1 Push the O-rings (8) onto resp. into the
pressure sleeve (5).
2 Fit the brake disk (2), the O-ring (3), and
the pressure sleeve (5) to the plunger (4)
and insert them into the spindle (1).
3 Insert the washer (6) into the spindle until
on top of the O-ring.
4 Press the locking ring (7) with a used
cylinder into the spindle until the locking
ring engages. Visual check!
Assembling the
1 Insert the O-rings (2) and (7) into the
spindle
pressure sleeves (3) and (6). Fit the
(mounting the
ring (8) to the pressure sleeve (6).
inner parts)
2 Press the pressure sleeve (3) into the
only applicable
spindle (1).
for PHE 3 X
3 Push the brake ring (4) and the pressure
sleeve (6) over the plungerand insert them
into the spindle (1).
4 Insert the washer (9) into the spindle until
on top of the O-ring (8).
5 Press the locking ring (10) with a used
cylinder into the spindle until the locking
ring engages. Sight control through the
service
Mount the rolls (6) completely with the
gear for adjustment before mounting
them.
position and leave it there
mounted cylinder.
From date of manufacture 01/96 the
Repair Instruction No. 175.8/95
1
2
1
1
2
1
2
3
PHE 3, PHE 3X
3
4
7
6
2
3
4
5
6 7
8
6 7 8 9 10
4
5
4
5
PAGE
12
9
10
11