Bose Virtually Invisible 791 Panduan Instalasi - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pembicara Bose Virtually Invisible 791. Bose Virtually Invisible 791 35 halaman. Installation guide
Juga untuk Bose Virtually Invisible 791: Panduan Instalasi (17 halaman), Panduan Instalasi (23 halaman)
English
TAB 2
Troubleshooting
Problem
The speakers do
• Check the settings on your receiver/amplifier. Refer to the owner's guide that came with it for
not play
instruction on settings.
• If other stereo speakers are connected to a second set of audio outputs on your amplifier/
receiver, make sure to select the proper A or B speaker setting to match the A or B outputs
connected to your Virtually Invisible
Only one speaker
• Check the balance control on your receiver/amplifier and make sure it is centered.
plays
• Trace the cord from the speaker in question to the receiver/amplifier and make sure no wires
from the + and – terminals on the receiver/amplifier are touching.
• Disconnect the cord from the receiver/amplifier channel and reconnect it to a different
receiver/amplifier channel.
• Check the cable connected to the speaker in question to be sure that no wires from the +
and – terminals are touching.
• Disconnect the cord from the speaker in question and reconnect it to another speaker.
• Replace and re-run the speaker wire only after you have followed the procedure above
and find no other source of the problem.
The bass or treble
• Check the tonal balance setting on your receiver/amplifier.
is weak
• Check for gaps between the speaker frame and the ceiling surface.
• Trace the cord from the speaker in question to the receiver/amplifier and switch the wires
connected to the + and – terminals at that end.
• Disconnect the cord from the receiver/amplifier channel and reconnect it to a different
receiver/amplifier channel.
Static or noise from
• Trace the cord from the speaker in question to the receiver/amplifier. Make sure the wires are
one speaker
in good condition, are firmly connected, and are not touching across terminals.
• Check the connections from the source of the music to the receiver/amplifier.
• Unscrew the speaker clamps and remove the affected speaker to reveal the cable. Make
sure the wires are in good condition, are firmly connected, and are not touching across
terminals.
• If the previous efforts do not solve the problem, refer to the proposed solutions for "Only one
speaker plays" above.
TAB 3
TAB 4
– If the performance is now fine, the problem lies in the original receiver/amplifier channel,
the component source of the music, or the connections between the receiver/amplifier and
the source. Check all of those to make sure they are performing properly. Reconnect the
speaker to the proper channel of a functioning receiver/amplifier.
– If the problem persists, its source is either the speaker wire or the speaker in question.
Follow the next instruction.
– If the performance is now fine, the problem lies in the original speaker. Contact your
authorized Bose dealer, who will arrange for service. Or, to contact Bose directly, refer
to the address list included in the carton.
– If the problem persists, its source is the speaker wires. Follow the next instruction.
– If this strengthens the bass performance, the problem was caused by inconsistent polarity
of the connections made at either end of the cable.
TAB 5
TAB 6
Possible solution
®
791 speakers.
TAB 7
TAB 8
R
EFERENCE
13